Minka Lavery 5414-281 Installation Guide
Add to my manuals1 Pages
Minka Lavery 5414-281 is a stylish and functional fixture that can elevate the ambiance of any room. With its easy installation process, you'll be able to enjoy its warm, inviting light in no time. This fixture is compatible with A19 E26 (MED BASE) light bulbs, allowing you to customize the brightness and ambiance to your preference.
advertisement
INSTALLATION INSTRUCTIONS
Item#5414-281 (New. 01/15/2015)
READ AND SAVE THESE INSTRUCTIONS
W
A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove the old fixture, including the mounting hardware.
2. Carefully remove the fixture from the carton and
Fig. 1
Set# A-021-220119B
-Mounting Plate
-Ground screw
-Mounting Screw*2
A check that all parts are included as shown in the illustration.
3. Position mounting plate (A) on the wall, and mark the location of two dry wall anchors (J). Pre-drill the holes for the dry wall anchors. Insert the dry wall anchors (J) into the wall.
4. Attach the mounting plate (A) to the junction box
5. Place the mounting screw (K) through the keyhole into the dry wall anchor (J) to secure the Mounting plate (A) as shown in Fig.1. using the Mounting screws (B). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
6. At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided. After the wires are connected, tuck them carefully inside the junction box.
FINISHING THE INSTALLATION (Fig.1)
7. Place fixture body (D) over mounting plate (A) and fasten with Screws (C).
8. Place the glass shade (F) followed by metal ring (G) over the socket. Use tool (I) and screw shell (H) to secure the glass into the fixture body.
9.
Install the A19 E26 (MED BASE) light bulb (not included) in accordance with the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
J
D
Socket ring # SKT-RING-26
E26 Socket Spanner: WRH-1-51
Fig. 2
FIXTURE
WIRES
Black or
Smooth
K
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
B
C
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
F
G
H
I
LA-2444E
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project