AF Lighting | 8619-1W | Instructions / Assembly | AF Lighting 8619-1W Instructions / Assembly

INSTALLATION INSTRUCTION FOR FIXTURE
8619 -1W
WARNING! SHUT OFF THE POWER AT FUSE OR CIUCUIT BREAKER.
MOUNTING THE FIXTURE
1. Shut off the power supply at the fuse box or circuit Wiring (See fig.2)
breaker box. Remove the old fixture from ceiling.
1. Connect the electrical wires as follows. Connect the
Including the universal mounting plate.
black wire from the fixture to the black (HOT) house
2. Carefully unpack your new fixture and lay out all the
wire. Connect the white wire from the fixture to the
parts on a clear area. Take care not to lose any
white (Neutral) house wire. Make all the wire nut
small parts necessary for installation.
was secured. You may wrap the connections with
3. Thread 2 mounting screws through the mounting
electrical tape. If your outlet box has a ground wire
screw holes from the back of the universal mounting
(Green or Bare Copper) connect fixture’s ground
plate.
wire to it. Other wise attach the bare copper fixture
4. Attach Universal mounting plate to the Outlet box
wire to the green ground screw on the cross bar.
using 2 Outlet Box Screws). The side of the
2. Tuck the wire connections neatly into the wall
universal mounting plate marked “GND” must face
junction box.
out.
5. Follow the wiring instructions carefully (See Fig.2). Fig.2
6. Attach the fixture body (B) onto the outlet box by
protruding 2 mounting screws through the mounting
screw holes on the fixture body (B), then tighten it
with 2 ball nuts (A).
7. Install the light bulb in accordance with fixture’s
specifications. DO NOT EXCEED THE MAXMUM
WATTAGE RATING!
Fig.1
Download PDF