AireRyder | LK34211AZ-C | Instructions / Assembly | AireRyder LK34211AZ-C Instructions / Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
LK34211
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
Fig.1
Lock Nut
Screw
Center Plug
Nipple
Fig.2
Screw
Wire Nut
Wire Nut
Motor
Switch Box
Wire Nut
Washer
Switch Box Cover
Light Kit
Switch Box
Hex Nut
Washer
Machine Screw
Pull Chain Switch
Motor
Switch Box
Terminal (Groove)
Terminal ( Tongue)
Switch Box Cover
Nipple
Set Screw
Light Kit
Glass Shade
1. Remove the switch box cover from the fan by loosing the three screws.
2. Unscrew and discard the center plug from the switch box cover.
3. For fan style that is shown in Fig.1: Please attach the nipple of the light kit to the hole of the
switch box cover, then thread the wires through the washer and hex nut, and secure them tightly.
4. For fan style that is shown in Fig.2: Please attach the nipple of the light kit to the hole in the
center of the switch box cover, then secure the light kit with the two set screws to switch box
cover.
5. Pull out the wires from the switch box. Make wire connections using the wire nuts:
---Connect the black wire from the light kit to the black or blue wire from the fan.
---Connect the white wire from the light kit to the white wire from the fan.
Carefully tuck wires back into the switch box cover.
6. Attach the switch box cover back to the switch box by using the three screws.
7. Install bulbs (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
8. Attach the glass shade to the light fixture with three machine screws.
9. Turn on the power at the main fuse or circuit breaker box. (You can control the light with the
pull chain.)
TM
060413
Download PDF