AireRyder | LK51214OR | Instructions / Assembly | AireRyder LK51214OR Instructions / Assembly

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
LK51214
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
Motor
Black or Blue Wire
Wire Nut
Black Wire
Center Plug
Light Kit
Switch Box
White Wire
White Wire
Hex Nut & Washer
Switch Box Screw
Switch Box Cover
Stem
Pull Chain
Socket
Glass Shade
E26 medium base spiral
fluorescent Bulb
(Max.13W, incluced)
1. Remove the switch box cover from the switch box of the fan by loosing the three switch box screws.
2. Unscrew the center plug from the switch box cover and discard it.
3. Thread the fixture wire through the switch box cover.
4. Attach the switch box cover to the light kit, then secure it with a washer and hex nut.
5. Pull out the wires from the switch box. Make wire connections using the wire nuts:
---The black wire from light kit to the black or blue wire from the fan.
---The white wire from light kit to the white wire from the fan.
---Carefully put wires back into the switch box.
6. Attach the switch box cover back to the switch box using the three switch box screws.
7. Install bulbs (included). See relamping label at socket area or packaging for maximum allowed
wattage.
8. Attach the glass shade to the light kit, then rotate the glass shade into the slot firmly.
9. Turn on the power at the main fuse or circuit breaker box.
(You can control the light with the pull chain.)
F
A
N
C
090406
O
Download PDF