Installation And Safety Instructions HC-1563 Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ 083109 IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off. Use of other manufacturers components will void warranty, listing and create a potential safety hazard. If you are unclear as to how to proceed, contact a qualified electrician. You don't need special tools to install this fixture. Be sure to follow the steps in the order given. Read instructions carefully. To reduce the risk of fire, electric shock, or personal injury, mount to outlet box or supporting system able to support the weight of the fixture Save these instructions. *OUTLET BOX *HOUSE GROUND WIRE *WIRE CONNECTORS MOUNTING BAR (A) CLEANING To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper. ORDERING PARTS Keep this sheet for future reference, and in case you need to order replacement parts. Parts for this fixture can be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts. NUT (B) *OUTLET BOX SCREWS GROUND WIRE (F) NIPPLE (C) CANOPY (H) COLLAR (E) COLLAR RING (I) BEFORE YOU BEGIN Carefully remove the fixture from the carton and check that all parts are included, as shown in figure 1. Be careful not to misplace any of the screws or parts which are needed to install this fixture. CHAIN (J) INSTALLATION FIXTURE LOOP (K) STEP 1: Attach fixture loop (K) to top of fixture. STEP 2: Secure mounting bar (A) to outlet box with outlet box screws (not supplied). Thread nut (B) on nipple (C) so that 3 threads are exposed above nut (B). Thread nipple (C) into mounting bar (A) and secure with nut (B). Attach collar (E) to nipple (C). SHADE (G) STEP 3: Using 2 pairs of pliers or chain breaks, open one link of chain (J) and connect it to the fixture loop (K) at the top of the fixture. - Please be sure to open chain link in an outward motion. Do not twist. STEP 4: Slide the collar ring (I) and canopy (H), in that order, over chain (J). Open one link on the other end of the chain (J) and attach it to the collar (E). BE SURE TO CLOSE ALL CHAIN LINKS COMPLETELY. GLASS RETAINING RING (L) FIGURE 1 *NOT INCLUDED INSTALLATION (continued) HC-1563 STEP 5: A. Use a listed wire connector to connect the fixture hot wire (black wire, or round and smooth tracer) to the supply hot wire. B. Use a listed wire connector to connect the fixture common wire (white wire, or square and rigid) to the supply common wire. C. Gently try to remove the wires from the connector. If you can remove the wires, carefully re-do the wiring connection. STEP 6: GROUNDING INSTRUCTIONS: Connect the supply ground wire, fixture ground wire, and mounting bar ground wire (pre attached) using the supplied wiring connector. Gently try to remove the wires from the connector. If you can remove the wires, carefully re-do the wiring connection. FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors. STEP 7: After wires are connected, tuck them carefully inside outlet box and then raise the canopy (H) against ceiling and thread the collar ring (I) to the collar (E). STEP 8: Raise shade (G) to socket and secure by threading glass retaining ring (L) onto socket. STEP 9: Install lamp (not supplied).