Sea gull lighting | 40124-05 | Installation guide | Sea Gull Lighting 40124-05 Installation Guide

HC-1533
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
IMPORTANT SAFETY INSTRUCTIONS
•
•
•
•
•
•
•
•
Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
If you are unclear as to how to proceed, contact a qualified electrician.
You don’t need special tools to install this fixture.
Be sure to follow the steps in the order given.
Under no circumstances should a fixture be hung on house
electrical wires, nor should a swag type fixture be installed on a
ceiling which contains a radiant type heating system.
Read instructions carefully.
Save these instructions.
BEFORE YOU BEGIN
022009
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
INSTALLATION
Carefully remove the fixture from the carton and check that all parts
are included, as shown in figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX.
STEP 1:
Install universal mounting plate (A) to outlet box using outlet box
screws (not supplied). Fixture mounting screws (B) should be
perfectly horizontal so fixture hangs straight.
STEP 2:
A. Use a listed wire connector to connect the fixture hot wire (black
wire, or round and smooth tracer) to the supply hot wire.
B. Use a listed wire connector to connect the fixture common wire
(white wire, or square and rigid) to the supply common wire.
C. Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do the wiring connection.
WIRE
CONNECTORS
FIXTURE
MOUNTING
SCREWS (B)
GLASS
(E)
*OUTLET
BOX
*SUPPLY
GROUND WIRE
FIGURE 1
CANOPY
(C)
UNIVERSAL
MOUNTING
PLATE (A)
GREEN
GROUNDING
SCREW (D)
RETAINING
RING (F)
*NOT INCLUDED
INSTALLATION (continued)
HC-1533
STEP 3:
GROUNDING INSTRUCTIONS: The green grounding screw (D) is to
be inserted into the hole with two raised dimples provided on the
universal mounting plate (A). Wrap the ground wire from the fixture (if
supplied) and the ground wire from the outlet box (bare metal or
green insulated wire) around the green grounding screw (D) on the
universal mounting plate (A). If uninsulated ground wire is on the
universal mounting plate (A), connect the ground wire from the fixture
(if supplied) and the outlet box to it using a small wire connector (not
supplied)
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
FINAL ASSEMBLY
Make sure no bare wires can be seen outside wire connectors.
STEP 4:
After wires are connected, tuck them carefully inside the outlet box.
STEP 5:
Place canopy (C) over outlet box so fixture mounting screws (B)
protrude through canopy (C). Thread cap nuts onto fixture mounting
screws (B) until canopy (C) is secured flush to the wall.
STEP 6:
Raise glass (E) to socket and secure by threading retaining ring (F)
onto socket.
STEP 7:
Install lamps.
Download PDF