The great outdoors by Minka Lavery | 72371-615B | Instructions / Assembly | the great outdoors by Minka Lavery 72371-615B Instructions / Assembly

INSTALLATION INSTRUCTIONS
Model # 72371
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
Fig. 1
1. Shut off power at the circuit breaker (avertissement!
couper le courant au niveau des fusibles ou du
disjoncteur) and remove the old fixture including
mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Unscrew the screws (I), and separate the back plate
(H) from cage (J) and remove cap nuts (G).
4. Thread the two studs (B) into the pre-drilled holes in
the circular strap (C) (Part#A-020) spaced the same
distance apart as the holes in the back plate (H),
then tighten with the hex nut (E). Note: The length of
studs (B) into circular strap (C) may be adjusted if
necessary.
5. Attach circular strap (C) (Part#A-020) using
mounting screws (F) (Part#8/32”*1”L) to the outlet
box (A) (Fig 1).
Set:
Circular Strap
Ground screw(1)
Mounting screws(2)
CONNECTION THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig.2.
making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the circular strap using the green screw (D)
(Part#8/32”*1/3”L) provided.
Fig.2
HOUSE
WIRES
BLACK
(HOT)
FINISHING THE INSTALLATION (Fig.1)
7. Align back plate (H) onto studs (B) and secure with
cap nuts (G). (Fig 1)
8. Install 2*35W / GU10 bulbs (three bulbs included) in
accordance with the fixture specification.—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
9. Align cage (J) to back plate (H) and secure with
screws (I) (top and bottom).
10. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape. (Fig .3)
Your installation is now complete. Return power to the
outlet box and test the fixture.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING
AND INSTALLATION.
FIXTURE
WIRES
GREEN OR
BARE
COPPER
(GROUND)
FIXTURE
WIRES
WHITE
FIXTURE
WIRES
BLACK
HOUSE
WIRES
WHITE
(NEUTRAL)
HOUSE
WIRES
GREEN OR
BARE COPPER(GROUND)
Fig 3
Caulking
Backplate
Download PDF