The great outdoors by Minka Lavery | 72422-212 | Instructions / Assembly | the great outdoors by Minka Lavery 72422-212 Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72422-212 (Rev. 06/19/2013)
READ AND SAVE THESE INSTRUCTIONS
WARNING !
S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
2. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
3. Attach the circular strap (A) to the outlet box using the
mounting screws (B) (Size: #8-32N*L0.5”). The side of
the circular strap (A) marked “GND” must face out.
4. Install 2 studs (C) into the circular strap (A), spaced
the same distance apart as the holes in backplate (D).
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in
figure 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the ground wire from the fixture
to it. Otherwise, connect the ground wire from the
fixture directly to the circular strap and secure with the
green screw provided. After wires are connected, tuck
them carefully into the outlet box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Align the backplate (D) over studs (C) and secure with
cap nuts (E).
7. To prevent moisture from entering the outlet box and
causing a shortage, use clear caulking (i.e.
Indoor/Outdoor silicone sealant) to outline the outside
of fixture backplate where it meets the wall leaving a
space at the bottom to allow moisture a means to
escape (Fig.3).
8. Pull up the latch (F) and open the door.
9. Install 3*60W B10.5 bulb(s) (not included) in
accordance with the fixture’s specification. (DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!) (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
10. When replacing the glass (G), pull up the latch (F)
and open the door. Loosen the clips and remove
glass (G). After replacing the glass, re-tighten the
glass clips, and then close the door.
11. For installing or replacing bulbs at a later date, pull
up the latch (F) and open the door. (Fig.1)
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
Set# A-020
- Circular strap
- Ground screw
- Mounting Screw*2
A
B
C
D
E
F
G
Fig.2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)
Fig.3
Backplate
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2326E
CAULKING
Download PDF