The great outdoors by Minka Lavery | 72396-143C | Instructions / Assembly | the great outdoors by Minka Lavery 72396-143C Instructions / Assembly

INSTALLATION INSTRUCTIONS
For Model 72396
WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the
old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
CONNECTINE THE WIRES (Fig.2)
3. While supporting the fixture, connect the electrical wires as
shown in figure 2. If your post has a ground wire (green or
bare copper), connect the fixture ground wire to it. If not,
consult your electrician for proper grounding. After the
wires are connected, tuck them carefully inside the post
(A).
COMPLETING THE INSTALLATION (Fig. 1)
4. Place the fixture (B) onto post (A), and secure with the 3
mounting screws (C)
5. Bulb (G) information: (1 x AC LED 10W included.)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
(NE PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Fig. 1
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps
for more details (Fig 4.)
a. Take off the fixture roof (D) by loosing two screws (E)
(Fig.1), then remove aluminum (O) by loosening screws
(K).
b. Remove wire nuts (L) hex-nuts (N) washers (M) and
carefully remove LED module (Q) for re-lamping. Note:
The LED module should be provided by specified
supplier. For better heat dissipation the LED module (Q)
should be installed with the heat transfer material (P)
when re-lamping
Your installation is now complete. Return power to the
junction box and test the fixture
HOUSE
WIRES
Black
(Hot)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or
Bare
Copper(G
d)
N
Fig. 3
M
K
L
O
P (Graphite sheet)
J (Glass)
I (Module ring)
H (Module screws)
Q (LED module)
Download PDF