The great outdoors by Minka Lavery | 8106-A138-L | Instructions / Assembly | the great outdoors by Minka Lavery 8106-A138-L Instructions / Assembly

INSTALLATION INSTRUCTIONS
Item#8106-A138-L (Rev. 04/29/2013)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
1. Shut off power at the circuit breaker and remove old
fixture including the mounting hardware.
Fig. 1
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
D
3. Pull the black, white and ground wires out of post (C).
E
4. Next, connect electrical wires while supporting the
lantern as shown in (Fig.2). If your outlet has a ground
wire (green or bare copper), connect the fixture ground
wire to it. If not, consult your electrician for proper
grounding. After wires are connected, tuck them
carefully inside the post. Align the lantern with post and
secure Bottom Assembly (A) with Sheet Metal Screws
(B) (Fig.1 & 2).
A
B
C
5. Bulb (D) information: (1 X AC LED 10W included.) (DO
NOT EXCEED THE MAXIMUM WATTAGE
RATING!!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
REPLACING LED MODULE (Fig.3)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any
decorative element to which the fixture is attached. See
installation steps for more details (Fig.3)
a. Shut off the power, use a screw driver to loosen the
screws (Q) and remove the glass shield (P) from the
aluminum cover (E).
b. Loosen the module screws (O) and remove the LED
module (L) and glass (M) from the white plastic ring (N).
c. Loosen screws (J) to remove aluminum plate (I) and
aluminum cover (F) from the bracket (G).
d. Remove wire connectors (H) to disconnect the LED for
re-lamping. (Note: The LED module should be provided
by specified supplier.)
e. For better heat dissipation the LED module (L) should
be installed with the heat transfer material (K) when
re-lamping.
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
Fig. 3
G
H
F
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
I
M
J
K
L
N
O
P
Q
LA-2273E
Download PDF