The great outdoors by Minka Lavery | 72432-261 | Instructions / Assembly | the great outdoors by Minka Lavery 72432-261 Instructions / Assembly

INSTALLATION INSTRUCTIONS
Item#72432-261
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Insert front glass (J) into door (I) and secure with clips
(k).
2. Insert back glass (L) and side glass (M) into lamp body
(G) and secure with clips (H).
Fig. 1
MOUNTING THE FIXTURE (Fig.2)
3. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture, including the
mounting hardware.
4. Carefully remove the new fixture from the carton and
check that all parts are included as shown in the
illustration.
5. Thread screws (A) into the pre-drilled holes in the
circular strap (C) spaced the same distance apart as
the holes in the back plate of the fixture body and
secure with hex nut (B).
6. Attach the circular strap (C) to the junction box using
the mounting screws (D) (size: #8-32N*L0.5”).The side
of circular strap (C) marked “GND” must face out.
Fig. 2
CONNECTING THE WIRES (Fig. 3)
7. At this point, connect the fixture wires as shown in
Fig.3, making sure that all wire connectors are
secured. If your outlet box has a ground wire (green or
bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to
the circular strap (C) using the green screw provided.
After the wires are connected, tuck them carefully
inside the outlet box.
FINISHING THE INSTALLATION (Fig.2)
8. Align the back plate (E) to screws (A) and secure it
with cap nuts (F).
9. To prevent moisture from entering the outlet box and
causing a short, use clear silicone sealant to outline
the outside of fixture back plate (E) where it meets the
wall leaving a space at bottom to allow moisture a
means to escape. (Fig. 4)
10. Install the light bulbs (not included) in accordance
with the fixture’s specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!). (NE
PAS DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Your installation is now complete. Return power
and test the fixture.
Set# A-020
- Circular Strap
- Ground Screw
- Mounting Screw*2
Fig. 3
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
Fig. 4
Note: Illustration (Fig.1) (Fig.2) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
Caulking
Backplate
Download PDF