The great outdoors by Minka Lavery | 9151-A357 | Instructions / Assembly | the great outdoors by Minka Lavery 9151-A357 Instructions / Assembly

INSTALLATION INSTRUCTION
For item#9151-A357 (Rev. 05/05/2012)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR
MOUNTING THE BACKPLATE (Fig.1)
1. Shut off the power at the circuit breaker and remove
the old fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any
small parts necessary for installation.
3. Attach the mounting plate (A) to the junction box
with screws (B). The side of the mounting plate
marked “GND” must face out.
4. Install screws (C) into the mounting plate (A) equal
distance apart to align with the mounting holes on
back plate (D).
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If
your outlet box has a ground wire (green or bare
copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly
to the mounting plate using the green screw
provided. After the wires are connected carefully
tuck them inside the junction box.
COMPLETING THE INSTALLATION
6. Place the back plate (D) over screws (C), and
secure with cap nuts (E).
7. Notice: To comply with UL Standards and maintain
product warranty, use clear silicone sealant to
outline the outside of the fixture back plate where it
meets the wall to prevent moisture from entering the
junction box while leaving a space at the bottom to
allow moisture to escape (Fig 4.). Failure to do so
will void any expressed warranty.
8. Install the 1*60W medium base bulb (G) (not
included) into socket (F) in accordance with the
fixture’s specification. Note: To prevent damage to
the bulb during installation, hold the bulb by the base
only while installing into the socket. (DO NOT
EXCEED THE SPECIFIED WATTAGE!) (NE PAS
DEPASSER
LA
PUISSANCE
NOMINALE
MAXIMALE!)
Your installation is now complete. Return the power
to the junction box and test the fixture.
Fig. 1
D
F E
A
C B
G
Fig. 2
FIXTURE
WIRES
Black or
Smooth
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
Fig. 3
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2068E
CAULKING
BACKPLATE
Download PDF