HomeSelects | 6292 | Instructions / Assembly | HomeSelects 6292 Instructions / Assembly

Important Safety Guide
www.HomeSelects.com
3. Remove the packages that protect the bulbs
and the light, such as foam, bubble pack material, etc.
2. Peel off the protective film to get optimum
light performance and avoid over-heating.
1. Open the package and remove the Grow Light.
Installation Instructions
during transportation
.
(like EPE foam beneath the bulbs and film on the acrylic shield) that protect the tubes
Before using the Grow Light, please remember to take away all the packaging materials
Please note:
in their original positions. If the sockets loosen, please refasten them.
sockets are intact if broken or cracked, please do not install them. Make sure the sockets are
Please check the following when you receive the item: Check whether the t u b e s or
fixture.
is securely installed before operating. Read and observe all the important notices on the
it will be exposed to the weather or to temperatures below freezing. Make sure the fixture
6. Do not use the fixture for other than intended use. Do not install or store the fixture where
parts, and before cleaning.
5. Always unplug the fixture from an outlet when not in use, before putting on or taking off
4. To avoid injury, do not contact hot parts such as lamps, the glass and the like.
3. Close supervision is necessary when any appliance is used by or near children.
damaged in any manner.
2. Do not operate fixture if it has a damaged cord or plug, or if it is malfunctioning or
3.
info@HomeSelects.com.
Thank you for purchasing this Grow Light. For more information please email us at
be removed from service and repaired before operating again.
3. Replace any part that shows signs of corrosion including the power cords, it must
corrosion or damage on the fixture.
2. Remove any salt build up (sediment if there is any) with a damp cloth to avoid
1. For maximum performance, inspect monthly.
Care and Operation
Ballast door wiring access
Wiring and Ballast replacement
Attach the S hooks and chain then hang securely.
both ends of it to turn 90 degree simultaneously.
Please note: Do not hold only one end of tube for turning, make sure that you hold
1. Carefully examine the fixture after installation. It should not be plugged in if there is water
on parts not intended to be wet.
simultaneously until it “clicks” in place, otherwise, it may damage the tube after
power on.
get wet, unplug the appliance immediately.
side. Hold both ends of the tube and twist 1/4 turn in same direction
fire hazards, special care as follows should be taken: If electrical components of the fixture
2. Insert the tubes into the sockets, make sure the tubes are inserted fully into each
Since water is employed in the use of Grow Light equipment, to avoid possible electric shock,
1. Gently remove the tubes and remove all bubble sheets around the tubes.
T5 High Output Tubes
Caution:
following:
To guard against injury, basic safety precautions should be observed, including the
Assembly and safety instructions
#6292 T5 - 2 tube HO
Grow Light
Download PDF