Warehouse of Tiffany RL9688 Assembly Instructions
Add to my manuals1 Pages
Warehouse of Tiffany RL9688 is a ceiling light fixture designed to be installed by qualified personnel. Its assembly requires basic tools and electrical knowledge. The fixture includes crystal rings, a canopy, and a shade, allowing for customization of its appearance. It features multiple ground connection points for safety and supports up to three G90 bulbs with a maximum wattage of 60W each. The fixture's design allows for height adjustment to suit different ceiling heights.
advertisement
◉
Touch to zoom
5 ASSEMBLY INSTRUCTIONS MODEL#:RL9688/3 NOTE: Only the technical personnel can be allowte fix and maintain IMPORTANT! Make sure that the power is switch off at the electricity sains supply before comsencing work. FIXING INSTRUCTIONS 1. Viredraving leupshede (19) will be fired on the Hain body pipe(i?) above, ft fixed hornhocd (:6), snd screw on the crystal rings (7). 2, Take out screw (4) and rotate it into crystal lifting ring (7) (at least Gan) and then tightened with washer (6) &hexagonal nut (5). 3.8otate the one nut of screv(4) till close to the first nut and then rotate screw (4) into batten(i3). Make sure scrow (4) should go through batten(13). 4.Use outlet hox screvs (14) to fix batten (13) on outlet box (1). 5. Take vut ring cover(9) from crystal lifting ring (7) and then let the cenopy ($) through crystal lifting ring (7). Adjust the crystal lifting rimg to 8 certain height, 6. Tighten the nut to fix on batten (13) in the right position 7.Cround Connection (See picture 1): there srs ona tapping hole 4 two dimnles. wind the supply ground wire (2) on the green zowand screw (15) and then put it into topping hole, Connect the fixture ground wire (3) with supply ground wire (2) by connecting terminal (12), Caution: DO NOT comncet ground wire with supply power vire, B. Connect fixture supply wire (10) with power supply wire (11). Caution: Remember to distinguish the positive and negative charges. (See picture 2) J. Push canopy (8) up to the ceiling. 10, Attach ring cover (9) on crystal lifting ring and fix canopy (8) as well, [1. Put shade (IB) on holder and tightened with out ring 2. Screw bulb in the holder, REPLACEMENT BULB Jo not exceed the zaxisua wattage. Aght bulbs recommended: RL9588/3 -El? 3 x GOW Max, Type В. LEANING CARE lean with a soft dry cloth AFETY INFORMATION ‚Lamp used must in rated voltage, and do not touch the bulb with bare hands . ways switch off the electricity supply and allow to cool for 10 minutes before hanging the light bulbs. ‚If the external cables have been desaged,Pls change or repair by manufacturer or service agency or professional electrician, In order to avoid the danger. — pa, CR ire lot box vire Crovnizg Detai) nm } White or Ribbed Finture Fire. EbITO Suppiy Vire Jpçs 16PCS 16PCS 16PCS “SP
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project