Kenroy Home 03070 Assembly Instructions

 FINIAL
SHADE
03072
(REPLACEMENT
PART)
LASS DOME
30256BLBSLD
(REPLACEMENT
PART)
LASS
HOLDER
SWITCH
T
SOCKET:
DD
BODY
OWER
CORD
Ere
AVAILABLE PARTS ARE:
03072 (SHADE)
30256BLBSLD (GLASS DOME)
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
READ INSTRUCTIONS ALL THE WAY THROUGH PRIOR TO ASSEMBLY.
THIS LAMP SHOULD TAKE APPROXIMATELY 10 MINUTES TO ASSEMBLE.
MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED.
WARNING: WHEN USING FOR OUTDOOR USE, FOLLOW IMPORTANT
SAFETY INSTRUCTIONS LISTED AT BOTTOM OF PAGE TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK, AND PERSONAL INJURY.
UNPACK THE LAMP
YOU SHOULD HAVE RECEIVED THE FOLLOWING PARTS IN THE PACKAGE:
FINIAL, SHADE, SHADE FABRIC, GLASS DOME AND LAMP BODY. TO
PROTECT THE FINISH, PLACE ALL PARTS ON A SOFT SURFACE.
NOTE: THIS LAMP INCLUDES A EXTRA OPTIONAL SHADE FABRIC THAT CAN
BE USED TO CREATE A SECOND DISTINCTIVE LOOK.
ASSEMBLE THE LAMP
1. INSTALL A 100 WATT MAXIMUM MEDIUM BASE TYPE "A" BULB (NOT
INCLUDED) INTO SOCKET.
2. SCREW GLASS DOME TO GLASS HOLDER.
3. PLACE SHADE ONTO GLASS DOME, THEN SCREW FINIAL TO TOP OF
SHADE.
4. PLUG THE POWER CORD INTO AN OUTLET AND TURN ON AT SWITCH.
SHADE FABRIC REPLACEMENT
PEEL OFF THE ORIGINAL SHADE FABRIC AND REPLACE WITH THE SECOND
OPTIONAL SHADE FABRIC (INCLUDED).
BULB REPLACEMENT
1. BEFORE REPLACING THE BULB, BE SURE THAT THE SHADE AND BULB
ARE COOL AND LAMP IS UNPLUGGED.
2. REMOVE THE SHADE, UNSCREW GLASS DOME AND EXISTING BULB
FROM SOCKET AND REPLACE WITH A NEW BULB THEN RECOVER THE
GLASS DOME AND SHADE. PLUG POWER SUPPLY CORD BACK INTO
OUTLET.
TROUBLE SHOOTING
1. IF YOUR LAMP DOES NOT LIGHT, CHECK PLUG AT THE OUTLET. MAKE
SURE THE PLUG IS FULLY AND PROPERLY INSERTED INTO THE POWER
OUTLET.
2. IF LAMP STILL DOES NOT LIGHT, UNPLUG FROM OUTLET. CHECK THE
BULB FOR A BROKEN FILAMENT. REPLACE BULB IF NECESSARY, PLUG IN
LAMP AND TURN IT ON.
3. IF THE LAMP STILL DOES NOT LIGHT, PLEASE CONTACT YOUR
DISTRIBUTOR OR PLACE OF PURCHASE.
IMPORTANT SAFETY INSTRUCTIONS
1. USE ONLY THREE—WIRE OUTDOOR EXTENSION CORDS THAT HAVE
THREE—PRONG GROUNDING PLUGS AND GROUNDING RECEPTACLES THAT
ACCEPT THE APPLIANCE'S PLUG.
2. GROUND FAULT CIRCUIT INTERRUPTER (GFCI) PROTECTION IS TO BE
PROVIDED ON THE CIRCUIT OR OUTLET TO BE USED FOR THE WET
LOCATION PORTABLE LUMINAIRE. RECEPTACLES ARE AVAILABLE HAVING
BUILT—IN GFCI PROTECTION AND ARE ABLE TO BE USED FOR THIS
MEASURE FOR THIS MEASURE OR SAFETY.
3. USE ONLY WITH AN EXTENSION CORD FOR OUTDOOR USE. SUCH AS AN
EXTENSION CORD OF CORD TYPE SW, SW—A. SOW, SOW-A, STW, STW-A,
STOW, STOW-A, SJW, SJW-—A, SJOW, SJOW-A, SJIW, SJTW-—A, OR SJTOW,
SJTOW-A.
12/2010 03070 INSTRUCTIONS