Direct vanity sink | 70D6-WWc-WM-2M | Instructions / Assembly | Direct vanity sink 70D6-WWc-WM-2M Instructions / Assembly

Direct vanity sink 70D6-WWc-WM-2M Instructions / Assembly
Instructions on installing the off-the-wall wall-mount faucet
system (US Utility Patent Pending)
Step 1: Align the back splash case to the top, back of the vanity and screw in the machine screws
using the allen wrenech until tightened.
Step 2: The spacer blocks are pre-installed as shown in the picture. Using this default
configuration allows you to fit Danze wall mount rough in model D106800BT. If you prefer to
use other brands, you might need to manipulate the spacer configurations/ locations/number of
spacers and secure the spacer blocks onto the protruded substrate before you can mount the
other rough in valves.
Step 3: Connect the flex water supply lines to the rough in, let them go through the 2 holes at
the bottom of the case as shown. Then insert the rough in valve stems through the 3 holes on
the back splash.
Step 4: Screw in wood screws through the back of the mounting plate into the spacers. You are
now completed with the off-the-wall wall-mount system (installation time about 10 min.).
Follow the instruction for the faucet trim to complete the faucet installation.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising