HP HSR6602 Router FIPS Enclosure (JG674A) Installation Guide

HP HSR6602 Router FIPS Enclosure (JG674A) Installation Guide
HP HSR6602 Router FIPS Enclosure (JG674A) Installation Guide-6PW101
BOM:3105A02G
Applying tamper evidence labels
HP HSR6602 routers meet the requirement of FIPS security level 2.
!
Installation preparation
!
Wear an ESD-preventive wrist strap, and make sure that the wrist strap has
a good skin contact and is well grounded.
!
Only use the screws and hex bolts that are supplied in the opacity shield kit
to secure the opacity shield.
Make sure the ambient air is above 10°C (50°F).
Clean the chassis before applying tamper evident labels. Alcohol-based
cleaning pads are recommended.
The installation procedures must be performed by qualified personnel.
Before installation, you should read the Compliance and Safety Manual for
router compatibility information.
Apply tamper evidence labels to all removable components on the device.
Two tamper evidence labels are provided with the FIPS enclosure
assembly.
Installing a FIPS enclosure
!
Part number:5998-4483R
Only use the screws and hex bolts that are supplied in the opacity shield kit to
secure the opacity shield.
Apply tamper evidence labels as shown in the figures.
To Install the right-side opacity shield:
Install hex bolts on the chassis as shown in the figures. (Remove the
fastening screws, if any, from where hex bolts are to be installed.)
Align the holes on the opacity shields with the hex bolts.
Press the opacity shields against the side panels, and use M3 countersunkhead screws to secure the opacity shields.
Install the left-side opacity shield in the way the right-side opacity shield is
installed.
1
2
5998-4483R
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement