PHANTOM 3 Intelligent Flight Battery Heater User Manual 2016.02 V1.0 Disclaimer Thank you for purchasing the Phantom 3 Intelligent Flight Battery Heater (hereafter referred to as “product”). Read this disclaimer carefully before using this product. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. Please use this product in strict accordance with the manual and be sure to pay attention to the warnings. SZ DJI Technology Co., Ltd. and its affiliated companies assume no liability for damage(s) or injuries incurred directly or indirectly from improper use of this product. Refer to the User Manual for applicable information not herein contained. This device complies with Part 15 of the FCC Rules. DJI is the registered trademark of SZ DJI Technology Co., Ltd. (abbreviated as “DJI”). Names of product, brand, etc., appearing in this manual are trademarks or registered trademarks of their respective owner companies. This product and manual are copyrighted by DJI with all rights reserved. No part of this product or manual shall be reproduced in any form without the prior written consent or authorization of DJI. This disclaimer is produced in various languages. In the event of divergence among different versions, the Chinese version shall prevail when the product in question is purchased in Mainland China, and English version shall prevail when the product in question is purchased in any other region. Profile The Phantom 3 Intelligent Battery Heater is used to preheat the aircraft battery in air temperatures between -4° and 41° F (-20° and 5° C). It uses the battery’s power to raise the battery temperature to the optimal operating range: 41° to 95° F (5° to 35° C). Using the battery heater ensures the safety and performance of your aircraft. Usage 1. Place a fully charged, powered off battery into the battery heater. 2.Power on the battery and allow it to warm for 5-10 minutes (time will vary depending on temperature). Be sure to monitor the battery at all times. 3. Power off the battery while it is still in the battery heater and leave an additional 3 minutes to ensure even heating. 1. 2. Insert the battery 3. Power on for 5-10 minutes Leave for 3 minutes Around 3% to 7% of battery power will be used for heating. A 3-stage overheat protection mechanism prevents the battery from overheating. The battery heater will automatically deactivate at temperatures exceeding 95°F (35°C), with additional failsafe barriers at 122° and 208° F (50° and 98° C). Once the desired temperature is reached, power off the battery to avoid draining it. Use immediately after removing it from the battery heater. Specifications Intended Battery PH3-4480mAh-15.2V Operating Air Temperature -20° to 5° C Cutoff Temperature 35±5 ℃ Power Rating <30 W Input Voltage 12-17.4 VDC Input Current <1.72 A Dimensions 61 × 83 × 113 mm © 2016 DJI. All Rights Reserved. Printed in China.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project