27TBF/G H1214
27TBF/G
H1214
27mm High Definition aluminum/magnesium alloy dome tweeter
with a wide, soft polymer surround. The dome and surround materials
give high consistency and excellent stability against variations in air
humidity. The diaphragm is protected by a highly perforated hexagrid
carrying an acoustic lens which tailors the high frequency roll off
characteristic.
The voice coil is wound on an aluminum voice coil former with
adequate ventilating holes to eliminate noise from internal air flow.
The voice coil is immersed in low viscosity magnetic fluid for high
power handling capacity and simplified crossover design.
The chassis is precision moulded from glass fibre reinforced plastic,
and its front design offers optimum radiation conditions.
100
50
95
90
40
85
SPL [dB]
30
75
70
20
65
60
Impedance [ohm]
80
10
55
50
100
1 000
10 000
0
Frequency [Hz]
The frequency responses above show measured free field sound pressure in 0, 30, and 60
degrees, mounted in a 0.6m by 0.8m baffle. Input 2.83 Vrms, microphone distance 0.5m,
normalized to SPL 1m. The impedance is measured without baffle using a 2V sine signal.
Nominal Impedance
6 Ohms
Voice Coil Resistance
4.8 Ohms
Recommended Frequency Range
2500 - 20000 Hz
Voice Coil Inductance
0.05 mH
Short Term Power Handling *
220 W
Force Factor
3.5 N/A
Long Term Power Handling *
90 W
Free Air Resonance
1100 Hz
Characteristic Sensitivity (2.83V, 1m)
91 dB
Moving Mass
0.34 g
Voice Coil Diameter
26 mm
Effective Piston Area
7.5 cm2
Voice Coil Height
2.0 mm
Magnetic Gap Flux Density
1.8 T
Air Gap Height
2.0 mm
Magnet Weight
0.25 kg
Linear Coil Travel (p-p)
0.5 mm
Total Weight
0.50 kg
Aug 2006-1
*IEC 268-5, via High Pass Butterworth Filter 2500Hz 12 dB/oct.
SEAS reserves the right to change technical data
T27-430
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement