Swanstone WK10000.010 Installation guide

Swanstone WK10000.010 Installation guide
Installation Instructions for
High-Gloss Window Trim Kit WTK-1
C
B
A
E
D
DIMENSIONS ARE FULL FACTORY LENGTHS
F
INCLUDED IN CARTON
A. Sill panel
B. Right jamb panel
C. Left jamp panel
D. One tube of adhesive
E. One tube of white caulk
F. One roll of pressure sensitive tape
TOOLS REQUIRED TO INSTALL
The only tools needed are a saber saw, drill, ruler, pencil, caulking gun.
DO NOT NAIL PANELS TO SILL.
THE HOLES IN THE PANELS ARE FOR MANUFACTURING
PRUPOSES ONLY.
CAUTION:
Read ALL instructions
carefully BEFORE starting
your installation.
Save this manual for
future reference
INSTALLATION PRODCEDURE
Allow panels to adjust to room temperature for at least 6 hours (65 - 90°).
Remove unnecessary window moldings, if any, and clean area of dirt, chipped paint, loose plaster, etc.
1. MEASURE BEFORE YOUR START. Measure
width of sill opening, mark, and cut 1 1/2" LESS
than the measurement. (Cut off the end with the
holes used for manufacturing purposes).
2. Measure depth of sill area, mark and cut panel
to exact size.
3. Cut left and right vertical panels to desired
height and depth. (Lining up with height of tub
surround material if applicable.) NOTE: AT THIS
POINT IT IS ADVISABLE TO TRIAL FIT ALL 3 PANELS.
Tape
4. Apply pressure sensitive tape and adhesive to
5. With vertical jamb panels cut to size, apply pres-
6. Caulk cut edges where necessary to seal out
underside of sill as illustrated. Be sure to center
sill panel 3/4” away from each side wall. Vertical
jamb panel will cover the gap. Remove backing
from pressure sensitive tape and final fit by pressing panel firmly into place.
sure sensitive tape and adhesive per pattern shown
above. Remove backing from pressure sensitive
tape and apply a bead of white caulk to end of
panel that overlaps sill. Place into position and
press down so tape and adhesive make good contact to wall.
moisture. It is not necessary to caulk overlapping
finished edges, unless desired.
NOTE:
IMPORTANT
Please allow unit to be installed 24 hours before
using. This will allow proper curing of adhesive and
caulking material.
Depending on the condition of the existing wall surface, additional adhesive may be required to ensure
contact between the substrate and the wall panel.
CARE AND CLEANING
CAUTION
The surface is stain and abrasion resistant; however, it requires reasonable care.
Wash regularly with warm water; use soft cloth with mild liquid detergent such
as Handy Andy, Mr. Clean, or Lestoil. Scouring pads made of nylon, saran or
polyethylene may be used but NEVER USE ABRASIVE SCOURING POWDERS,
CLEANERS OR PADS…THEY DULL THE FINISH. Protect finish with any fiberglass
wax or automotive paste wax.
Dry cleaning agents and solvents will damage the surface. Burning cigarettes will
damage and discolor surface.
The Swan Corporation
One City Centre
Suite 2300
St. Louis, MO 63101
p (800) 325-7008
f (314) 231-8165
FORM 526-11-07-2M
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement