DALI Multi-Sensors Ceiling Installation Box Installation Surface Mounting 55 60 Ø101 Ø52 Ø103 Ø86 Ø70 9 7 20 The WAGO DALI MSensor 02 is used with WAGO DALI Modules (753-647 DALI Multi-Master Module or 750-641DALI/DSI Module). It has been designed for the following principal applications: - Individual offices - Open-plan offices - Training/presentation rooms - Corridors, passageways and garages The Multi-Sensor features both motion and light detection. As an option, the sensor can be operated via remote control (from Tridonic). The sensor enables both motion detection and daylight-dependent lighting control; both of which can also be deactivated. Addressing is performed via rotary switch or WAGO DALI Configurator. Parameters can be adjusted individually via WAGO DALI Configurator. Power supply is provided via DALI line. The number of sensors, which can be operated on a DALI line, depends on the total power consumption of the specific devices and address range for the actuators and sensors. Due to the capacity of the DALI bus, a maximum of 16 DALI sensor couplers must be operated on the DALI Multi-Master Module (753-647). 4,2 5 6,9 Ø4,5 46 Ø86 40 55 Installation notes: • The DALI MSensor 02 is supplied directly via DALI line. • DALI is not SELV (Safety Extra Low Voltage). The installation instructions for mains voltage therefore apply. • The detection range of the sensor must be within the lighting area of the controlled luminaires. • The detection ranges of the sensors must not overlap as this may influence the lighting control. • When installed at a height other than the recommended installation height (2.5 m), the presence and light sensor might show different characteristics. When mounted at a higher level, its sensitivity is reduced. If mounted at a lower level, its range is diminished. • Heaters, fans, printers and copiers located in the detection range may cause incorrect presence detection. Item description DALI-MSensor Version 02 5DPI 41rc (Ceiling Installation) 02 5DPI 41w (Box Installation) 02 5DPI 41rs (Surface Mounting) Item No. 2851-8301 2851-8302 2851-8303 Technical Data Ø of detection range, mounted at a height of 2.5 m 5m Extension of the detection range 2 m (if mounted at a height of 2.5 m and swivelled through 15°) - Swivel design yes no Swivel range ± 15° - Detection angle Light measurement at the sensor head 360° 10 ... 650 lx (The measured value at the sensor head corresponds to approx. 15 to 2,000 lux on the surface measured.) Remote control range 5m wago.com/2851-8301 Data sheet and further information, see: :$*2.RQWDNWWHFKQLN*PE+&R.* 6XEMHFWWRGHVLJQFKDQJHV .2017 wago.com/2851-8302 Postfach 2880 - D-32385 Minden Hansastr. 27 - D-32423 Minden Tel.: +49(0)571/887-0 Fax: +49(0)571/887-169 wago.com/2851-8303 E-Mail: [email protected] www.wago.com Technical Data Technical Data Power supply via DALI line Current consumption 6 mA from DALI line General settings: Motion detection Operating temperature 0 °C ... +50 °C Lighting control enabled Storage temperature -25 °C ... +55 °C Setpoint, lighting control 150 Ix Degree of protection IP20 Power-on setting no action Wire type and cross-section 6ROLGRUƮQHVWUDQGHGZLUHVUDQJLQJ from 0.5 mm² to 1.5 mm² (AWG 20–16) Bright-out timeout 10 min. Bright-out threshold 150 % Control speed 4 HQDEOHGRQRƬ Switch-on value auto (calculated) Rotary switch 0, broadcast Motion detector settings: Fade-in time < 0.7 s Presence value regulated Run-on time 20 min. Fade time 5.6 s Absence value 3% 6ZLWFKRƬGHOD\ 10 min. )DGHRƬWLPH 5.6 s 0DQXDORƬ 10 min. Light detection h Motion detection h 70° d1 h* d1 d2 1,7 m 2,4 m 3,4 m 2,0 m 2,8 m 4,0 m 2,3 m 3,2 m 4,6 m 2,5 m 3,5 m 5,0 m 2,7 m 3,8 m 5,4 m 3,0 m 4,2 m 6,0 m 3,5 m 4,9 m 7,0 m 4,0 m 5,6 m 8,0 m * The recommended maximum room KHLJKWIRURƱFHDSSOLFDWLRQVLVP and for corridor applications 4 m, for example. Calculation of the diameter: d = 2 x tan (0.5 x a) x h 90° d2
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021