led thermal waterfall vessel sink faucet
LED THERMAL WATERFALL VESSEL SINK FAUCET
Dear Valued Customer,
SUMERAIN would like to take this opportunity to thank you for purchasing SUMERAIN products. It is our sincere hope that you are completely satisfied with your new purchase. All SUMERAIN products are carefully engineered, and factory tested to provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated instructions. We welcome any questions or comments you may have and look forward to assisting you in the future. If you have any questions regarding this product, call
+86-750-2731579 or email to [email protected]
SUMERAIN customer service department
1. Unpack your new product and ensure that all the parts are contained in the packaging. Keep the product in its original box until you ready to install it.
2. Locate water supply inlets and shut off the water supply valves. These are usually found near the water meter. if you are replacing an existing unit, remove the old unit and clean the mounting surface thoroughly.
3. Observe all plumbing and building codes in your area.
4. It is recommends calling professional if you are uncertain about installing this product.
Philips screwdriver Allen wrench Adjustable wrench Channel locks Thread Sealant
This product has been manufactured and tested to the highest quality standards by SUMERAIN sanitary Inc("SUMERAIN").This warranty is limited to SUMERAIN products which are purchased by a consumer in the China after Jan 1,2010 and installed in China or the state which has SUMERAIN technical support department locally.(visit http://www.sumerain.com/en/supportcenter.asp for review the state list of SUMERAIN technical support department).If the faucet should leak or drip during normal use,SUMERAIN will, free of charge, mail to the purchaser the cartridge necessary to put the faucet in good working condition. If a defect is found in normal residential use, SUMERAIN will, at its election, repair, provide a replacement part or product, or make appropriate adjustment.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only (exclusive online retail original customer, online retail original customer cover by the "Online CONSUMER Limited Lifetime WARRANTY & Return policy"), This warranty is not-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your SUMERAIN manufactured product. SUMERAIN warrants this product against defects in material or workmanship as follows: SUMERAIN will repair at no charge for parts only or, at its option, replace any product or part of the product that proves defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. If
SUMERAIN unable to provide replacement, SUMERAIN may elect to provide similar model upon close value.
It is the responsibility of the customer to check for any material finish defects before installation. SUMERAIN doesn't warranty these finishes after the fixture has been installed.
ELECTRONIC FAUCETS WARRANTY
SUMERAIN warrants that its electronic faucets, valves and controls to be free from manufacturing defects in material and workmanship under normal use for three(3) years from the date of purchase and waterflow impeller-dynamo (generate power for
LED faucet) for six(6) months from the date of purchase.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences, if you are a consumer who purchased the product for use primarily for personal,family,or household purposes, this warranty extends for 5 years since the product originally installed (Extend max 1 month From the date of purchase).if you purchased the product for use primarily for any other purpose,including,without limitation, a commercial purpose or is installed outside of China, or if the finish is gold, non-Vibrant or a painted or powder coated color finish this warranty extends only for one year, with respect to SUMERAIN and commercial products.
THIS WARRANTY DOES NOT COVER, AND SUMERAIN WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from normal wear and tear, improper installation, improper maintenance, misuse,abuse,negligence,accident or alteration or the use of abrasive or caustic cleaning agents or "no-rinse" cleaning products, or the use of the product in any manner contrary to the product instructions. Conditions in the home such as excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for installation or reinstallation of the product.
D. Accessories, connected materials and products (including but not limited in handshower flexible hose, spray flexible hose, handshower), or related products not manufactured by SUMERAIN
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your SUMERAIN retailer or contact technical service at: [email protected]
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and the place of purchase.
2. A description of the problem (Download URL: http://www.sumerain.com/download/servicerequest/sheet.pdf
and fill out the
Service Request Sheet).
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured to :
SUMERAIN FACTORY SUPPORT CENTER ,25 Building,Tangkou industrial park,Shuikou Town,Jiangmen Kaiping city,
Guangdong provice,China 529301
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
Repair or replacement (or, in limited circumstances, refund of the purchase price) as provided under this warranty is the exclusive remedy of the purchaser. SUMERAIN neither assumes nor authorizes any person to create for it any obligation or liability in connection with this product.SUMERAIN shall not be liable to purchaser or any person for any incidental, special, or consequential damages, arising out of breach of this warranty or any implied warranty (including merchantability) Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal right, and you may have other rights which vary from state to state. You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnusson-moss warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your SUMERAIN product for any damage or visible defect. Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. if you have questions at any time about the use,installation,or performance of your SUMERAIN product, or this warranty, please call or email us at +86-750-2731579, [email protected]
Number of Handles
Faucet Total Height
Max deck thickness
Faucet Body Material
Faucet Spout Material
Working water press
LED power supply
LED Color changing
Low battery warn
Packing box size
Bathroom Sink Faucets
180mm [ 7-1/16 Inch]
138mm [ 5-7/16 Inch]
80 mm [ 3-1/8 Inch]
87 mm [ 3-7/16 Inch]
45 mm [ 1-3/4 Inch]
6.8L/M [ 1.8 GPM]
304 # Stainless steel
1.1 KG [ 2.42 lbs ]
1.6 KG [ 3.52 lbs ]
0.2 ~0.8 Mpa
AA Battery x 3PCS
< 30 ℃ [ 86 °F ]
30 ℃~ 40 ℃ [ 86 °F ~ 104 °F ]
40 ℃~ 48 ℃ [ 104 °F ~ 118.4 °F ]
> 48 ℃ [118.4 °F]
260mm[10-1/4”]x 185mm[7-1/4”] x 100mm[3-15/16”]
1. BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding.SUMERAIN recommends calling a professional if you are uncertain about installing this product!, this product should be installed in accordance with all local and state plumbing and building codes.
2. SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found near the water meter. if you are replacing an existing unit, remove the old unit and clean the mounting surface thoroughly.
3. CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all the following items are included.
AA battery holder
If any of these items are missing, please contact SUMERAIN consumer service at +86-750-2731579 or email to: [email protected]
4. INSTALLATION HOLES INSPECTION
Verify that the hole sizes and positions on the desk is correct, the diameter of mounting hole should be 32mm(1-1/4”) at least and maximum 40mm(1-9/16”) ,the max thickness of deck should be 45mm(1-3/4”)
5.1 Turn on your shut-off valve for cleaning the hot and cold water supply pipe before connect to the faucet, allow the water flush
3~5 minutes to flush out dirt and debris. Shut off the water supply again after finish.
Attach the shank to the bottom of your faucet.
Place the O-ring on the mounting surface of faucet’s bottom.
Attach both hot and cold steel braided water supply lines provided, to their respective threaded connectors at the bottom of the faucet, Hot: left, Cold: Right. Tighten both supply lines by hand, and then with a wrench or grips, but be careful not to over tighten or you may strip or crack the threaded connectors.
position the faucet with shank and O-ring on the mounting surface.
Attach the rubber washer, and then the lock nut provided to the shank from underneath the countertop and tightens with a wrench or grips until the faucet is secured.
5.7 Place 3 PCS AA battery into the battery holder (please don’t make mistake on the Plus-n-Minus or else it will damage electronic components), then turn on the power switch (Notes: 1th.No Battery are including in the shipment; 2th. Battery holder’s switch is turn on by default before delivered).
5.8 Fasten the battery top cover.
the battery holder onto wall by the screws and anchor.
5.10 Connect battery holder to the plug receptacle which comes from faucet bottom.
5.11 Attach the hot and cold water hose from the faucet to each of the hot and cold supply valve,tighten the mounting nut by hand or wrench.
6.1 Turn on hold and cold water supply and check all connection for ensuring no leaking anywhere.
The LED light will illuminate the water and activate different color rely on water’s temperature as soon as the water through the
Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning.
Cleaning Materials for faucets and showers
Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the following points when cleaning faucets and showers:
■ Only use cleaning materials which are explicitly intended for this type of application.
Never use cleaning materials which contain hydrochloric, formic, phosphoric, or acetic acid, as they cause considerable damage.
Never mix one cleaning material with another.
Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge pads, or micro fiber cloths.
Cleaning instructions for faucets and showers
Please follow the cleaning material manufacturer's instructions. In addition, pay attention to the following points:
Clean the faucets and showers as and when required.
■ Use the amount of cleaning product and the amount of time recommended by the manufacturer. Do not leave the cleaner on the fixture longer than necessary.
■ Regular cleaning can prevent calcification, if scale deposits are noticed on the faucet surface or the spout, you can clean it by a commercial limescale remover, such as Lime-Away® or CLR®.Dilute the remover according to the label instructions.
The faucets might have some rusty if your faucet under hard water condition, please rub it with aluminum foil dipped in water until the surface is nice and smooth, and wipe it use a small amount of chrome polish or maybe something like car wax(such as
Meguiar®,Turtle Wax®) or polish.
For stainless steel faucet and spout both made of solid stainless, normally this finish has not protective coating on it(in particular waterfall spout inside),stainless steel is by its material nature very tarnish resistant, but by no means tarnish or stain proof. This finish might oxidize naturally over time and react to its environment. Keep your stainless fixture wiped clean and dry and use only a cleaner specifically made for stainless steel (such as Weiman®, CLR®).
When using spray cleaners, spray first onto a soft cloth or sponge, never spray directly onto the faucet as droplets can enter openings and gaps and cause damage.
After cleaning, rinse thoroughly with clean water to remove any cleaner residue.
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note: if the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced or injury could result.
Damage caused by improper treatment is not covered under the warranty.
Faucet leaks from the handle
The water pressure is too low
The spout sprays water all over
Water is leaking from the faucet under the sink
A. Tighten the packing nut
B. Replace the "O" ring or packing
C. Replace the cartridge
A. Make sure the water supply valves under the sink are turned on all the way
B. Clean or replace the aerator
C. Check plumbing system for water pressure problems
A. Clean or replace the aerator
B. Replace the aerator washer
A. Check the water supply connections to the faucet
B. Inspect the water supply lines or hoses for leaks
Handle is loose
LED flash per 3 second
LED does not illuminate
A. Remove the cap and tighten the screw
B. Locate and tighten the hex set screw
C. Remove the handle and check for stripped teeth on the stem.
Low battery and need to replace battery
A. Battery run out and need to replace battery
LED color only yellow or purple B. Water temperature sensor damage or short out
LED light on always
unwater until no water leave on the switch (the LED will be illuminate as soon as the two switch meet water.
HONGKONG SUMERAIN SANITARY INDUSTRY CO., LIMITED
Address: ROOM 1018, HOLLYWOOD PLAZA 610 NATHAN ROAD MONGKOK, KL
Factory Address: 25 building Tangkou Industrial Park,Shuikou town, Kaiping City, Guangdong Province, China (Mainland)
Toll Free: 400-0999-075 (China mainland)
E-mail: [email protected]
SUMERAIN INTERNATIONAL GROUP – AMERICA SALES Branch
Address: 13455 Harper Dr.
Saratoga, CA 95070
E-mail: [email protected]
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project