Home Decorators Collection | 0804800210 | Instructions / Assembly | Home Decorators Collection 0804800210 Instructions / Assembly

Home Decorators Collection 0804800210 Instructions / Assembly
 HOME
DECORATORS
COLLECTION
HDC# 08048 MFG# TW-18418IY
SOUTHPORT END TABLE 25"Hx21"W x16"D
ASSEMBLY INSTRUCTIONS
Note: Before assembly, please be sure to work on a soft,
flat surface to avoid any damage to the finish.
Made In China
7 7
ON
P 1/4
BEFORE ASSEMBLY
IMPORTANT NOTE: READ CAREFULLY BEFORE ASSEMBLY TO PREVENT DAMAGE TO PARTS. Following
instruction listed below in the proper sequence as numbered to assure fast, easy and correct assembly.
ASSEMBLY TOOLS REQUIRED
2.” 0° 4
Rubber Mallet
Electric drill
"+"Screw driver "."Screw driver
WOODEN DOWEL INSTALLATION PROCEDURE
(1) (2) (3) )
(1) FILL HOLE 1/4 FULL OF GLUE.
(2) GENTLY TAP DOWEL INTO HOLE
WITH RUBBER MALLET OR USE HAND Q
PRESS IN. 6
DO NOT USE HAMMER
(3) WIPE AWAY EXCESS GLUE.
0
PARTS LIST
BOTTOM PANEL
1 PC
<<
ACROSS PANEL
2 PCS
7
LEFT SIDE FRAME
1 PC
=
RIGHT SIDE FRAME
1 PC
TABLE TOP
SHELF
1 PC
P 2/4
HARDWARE LIST
SHELF HOLDER | ALLEN KEY | GLUE WOOD DOWEL
1 PC 1 PC 4 PCS
WOOD DOWEL | ROUND HEAD BOLT
8 PCS FLAT WASHER 4 PCS
12 SETS
3 | °® ВЕ
(4) (5) (6)
—|
OD
Oum» о) N
(1)
STEP 1: ASSEMBLE ACROSS PANEL (B) ON BOTTOM PANEL (A)
« FILL RELEVANT HOLES 1/4 FULL OF GLUE, INSERT WOOD DOWEL (1) INTO THESE HOLES.
(DETAILS SEE WOODEN DOWEL INSTALLATION PROCEDURE ON PAGE 2)
* USE ROUND HEAD BOLT € FLAT WASHER (2) TO ATTACH ACROSS PANEL (B) AND BOTTOM PANEL
(A) TOGETHER BY ALLEN KEY (4).
STEP 2:
PULL OUT THE DRAWER
USE FINGER TO PRESS DOWN THE PLASTIC DRAWER STOPPER UNDER THE LEFT AND RIGHT DRAWER,
THEN PULL OUT THESE DRAWER AS SHOWN.
”
><. -
—
P 3/4
STEP 3: ASSEMBLE SIDE FRAME (C € D) AND TABLE TOP (E)
« FILL RELEVANT HOLES 1/4 FULL OF GLUE, INSERT WOOD DOWEL (1) & (6) INTO THESE HOLES.
(DETAILS SEE WOODEN DOWEL INSTALLATION PROCEDURE ON PAGE 2).
* USE ROUND HEAD BOLT € FLAT WASHER (2) TO ASSEMBLE SIDE FRAME (C € D) AND BOTTOM (A) €
TABLE TOP (E) TOGETHER.
STEP 4: ASSEMBLE SHELF (F) AND PLACE DRAWER
* INSERT SHELF HOLDERS (3) INTO THE HORIZONTAL HOLES INSIDE OF SIDE FRAME (C & D)
THEN PUT SHELF (F) ON THE SHELF HOLDERS.
« INSERT DRAWER UNDER THE TABLE ТОР (E) AS SHOWN.
P 4/4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising