front control electric ranges

front control electric ranges
FRONT CONTROL ELECTRIC RANGES
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
WEE510S0F
This manual covers several models. Your model may appear different
from the models depicted. Dimensions given are maximum dimensions
across all models.
A
ELECTRICAL CONNECTION
B
C
To properly install your range, you must determine the type of electrical
connection you will be using and follow the instructions provided for it
here.
■■ Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial/rating plate. The model/
serial/rating plate is located behind the oven door on the top righthand side of the oven frame.
■■ This range is manufactured with the neutral terminal connected to
D
the cabinet. Use a 3-wire, UL listed, 40- or 50-amp power supply
cord (pigtail). See the following Range Rating chart. If local codes
do not permit ground through the neutral, use a 4-wire power supply
cord rated at 250 volts, 40- or 50-amps and investigated for use with
ranges.
Range Rating*
Specified Rating of
Power Supply Cord Kit
and Circuit Protection
120/240 Volts
120/208 Volts
Amps
8.8 - 16.5 KW
7.8 - 12.5 KW
40 or 50**
16.6 - 22.5 KW
12.6 - 18.5 KW
50
*The NEC calculated load is less than the total connected load listed on
the model/serial/rating plate.
**If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For
50-amp rated cord kits, use kits that specify use with a nominal 1³⁄8"
(3.5 cm) diameter connection opening.
■■ A circuit breaker is recommended.
E
F
A.1³⁄16" (3.0 cm) height from
cooktop to top of vent
B.297⁄8" (75.9 cm)
C. Model/serial/rating plate
(located behind the oven door
on the top right-hand side of
the oven frame)
D. 36" (91.4 cm) height to top of
cooktop edge with leveling
legs screwed all the way in*
E.2825⁄64" (72.1 cm) max. depth
from front of console to back
of range
F.291⁄64" (73.7 cm) max. depth
from handle to back of range
IMPORTANT: Range must be level after installation. Follow the
instructions in the “Level Range” section. Using the cooktop as a
reference for leveling the range is not recommended.
*Range can be raised approximately 1" (2.5 cm) by adjusting the
leveling legs.
Page 1 of 1
Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10842010
05/23/2016
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop
depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop
height.
IMPORTANT: If installing a range hood or microwave hood combination
above the range, follow the range hood or microwave hood combination
installation instructions for dimensional clearances above the cooktop
surface.
Range may be installed next to combustible walls with zero clearance.
D
B
C
A
E
K
G
H
F
I
J
I
A. 18" (45.7 cm) upper side cabinet to countertop
B. 13" (33 cm) max. upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to top of cooktop, see NOTE*.
E. 30" (76.2 cm) min. opening width
F. The shaded area is recommended for installation of grounded
outlet.
G.13¹⁄8" (33.3 cm)
H.7¹¹⁄16" (19.5 cm)
I.4¹³⁄16" (12.2 cm)
J.3¹¹⁄16" (9.4 cm)
K. Cabinet door or hinges should not extend into the cutout.
*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet
is shielded by not less than ¹⁄4" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an uncovered wood or metal cabinet.
Page 2 of 2
Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10842010
05/23/2016
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement