Husky H4820 Instructions / Assembly

Add to my manuals
1 Pages

advertisement

Husky H4820 Instructions / Assembly | Manualzz

Operation

1

Operating the sander

□ This Dual Action Sander is designed to operate on 90 PSIG .

Lower pressure (below 90 PSIG) will reduce performance of the tool . Higher air pressure (over 90 PSIG) raises the performance of the tool beyond its rated capacity and could cause serious damage to the tool and the user .

2

Installing the sanding pad

WARNING: Disconnect the tool from the air source before servicing or changing any accessories .

WARNING: Always use the sanding discs with the rated tool RPM .

□ Lock the drive spindle in place before attaching the sanding pad (B) . Rotate the spindle lock until the spindle lock engages with the drive spindle . Hand tighten the sanding pad (B) in a clockwise direction .

□ Adjust the rotation speed by turning the air regulator to the maximum rotation speed .

3

Removing the sanding pad

WARNING: Disconnect the tool from the air source before servicing or changing any accessories .

□ Use the open end wrench (C) to secure the bearing seat, then use your hand to loosen and remove the sanding pad

(B) .

4

Sanding surfaces

WARNING: You must wear ANSI approved eye protection during the operation; failure to follow this may result in serious injury or damage to the operator .

WARNING: Hearing protection is strongly recommended . A protective respirator is recommended .

□ Connect the air source and run the tool .

□ Do not operate the tool with the spindle locked or the sander will stall when pressure is applied to the pad .

□ Always use the correct grit practical for the sanding operation .

6

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement