GFD45GSSK/GSPK

GFD45GSSK/GSPK
GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
GAS DRYER RATING
120V
27
33
60Hz, 6A
EXHAUST OPTIONS: 3-way via rear, left, and
bottom.
CIRCUIT REQUIREMENTS: An individual,
properly grounded branch circuit, protected by a
15-20 amp circuit breaker or a time-delay fuse, is
required.
39-3/8
NOTE: Dryer wall outlet must be located within
36" of service cord entry and accessible when dryer
is mounted in position.
INSTALLATION INFORMATION: For complete
information, see installation instructions packed
with your dryer.
4-3/8
5-3/8
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Specification Revised 6/16
GFD45GSSK/GSPK
GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer
SPECIAL INSTALLATION REQUIREMENTS
STACKED INSTALLATION:
Brackets for stacking dryer over washer are not included with the
washer. Order part no. GEFLSTACK or part no. WE25X10018.
STACKED DIMENSIONS (IN INCHES)
50-5/8
24-7/8
3-1/2
3
ALCOVE OR CLOSET INSTALLATION:
If your dryer is approved for installation in an alcove or closet, it will
be stated on a label on the dryer back.
The dryer MUST be exhausted to the outside.
39-3/8
Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side, 3" front and rear
Minimum vertical space from floor to overhead cabinets, ceilings, etc.
is 52".
Closet doors must be louvered or otherwise ventilated and must
contain a minimum of 60 sq. in. of open area equally distributed. If
this closet contains both a washer and a dryer, doors must contain a
minimum of 120 sq. in. of open area equally distributed.
o other fuel-burning appliance shall be installed in the same closet
N
with a gas dryer.
BATHROOM OR BEDROOM INSTALLATION:
The dryer MUST be exhausted to the outdoors.
he installation must conform with the local codes, or in the absence
T
of local codes, with the National Electric Code and National Fuel Gas
Code, ANSI Z223 for gas dryers.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET
INSTALLATIONS:
Minimum clearances to combustible surfaces 0" both sides, 3" rear.
PEDESTAL DIMENSIONS
(IN INCHES)
SBSD137HWW - WHITE
This optional 13" pedestal
raises the door opening and
height of the washer or dryer.
Feet on 13" pedestal allow it to
adjust to 13-3/8" height.
FOR MORE INFORMATION ON VENTING KITS AND
ACCESSORIES,
PLEASE CALL 1-800-GE-CARES.
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
27"
13"
28-3/4"
Specification Revised 6/16
GFD45GSSK/GSPK
GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer
DRYER EXHAUSTING INFORMATION – METAL DUCT ONLY
For complete information, see installation instructions packed with your dryer.
DUCTING MATERIALS: For best performance, this dryer should be vented with 4”
diameter all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed
flexible metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations,
it may be necessary to connect the dryer to the house vent using a flexible metal (foiltype) duct. A UL-listed flexible metal (foil-type) duct may be used ONLY in installations
where rigid metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4”
diameter can be maintained throughout the entire length of the transition duct. Please
see installation instruction packed with your dryer for complete instructions when using
flexible metal (foil type) ducting.
Best performance
Maximum length of 4"
dia. rigid metal duct
Exhaust hood type
A
A
4
B
Domestic
dryer models
2-1/2
EXHAUST LENGTH CALCULATION:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the
side or bottom of dryer, add one turn.
2.The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated
is shown in the table.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be
treated as a 90° elbow.
A turn over 45° should be treated as a 90° elbow.
7.5 cu. ft.
capacity models
gas dryers
Number
of
90°
turns
0
1
2
3
4
A
4"
opening
90 ft.
60 ft.
45 ft.
35 ft.
25 ft.
B
2-1/2"
opening
60 ft.
45 ft.
35 ft.
25 ft.
15 ft.
Dryers must be exhausted to the outside.
CAUTION: For personal safety do not terminate exhaust into a chimney, under any
enclosed house floor (crawl space), or into an attic, since the accumulated lint could create
a fire hazard or moisture could cause damage. Never terminate the exhaust into a common
duct or plenum with a kitchen exhaust, since the combination of lint and grease could
create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird
nesting, etc. The wall cap must also be located at least 12" above the ground or any other
obstruction with the opening pointed down.
FOR MORE INFORMATION ON VENTING KITS AND ACCESSORIES, PLEASE
CALL 1-800-GE-CARES.
2-1/2
3-1/2
1-3/4 Gas Pipe Electrical
12
Connection Connection
Specification Revised 6/16
GFD45GSSK/GSPK
GE Appliances 7.5 Cu. Ft. Capacity Frontload Dryer
FEATURES AND BENEFITS
Steam Refresh - Rejuvenate lightly worn clothes by getting rid of wrinkles and odors with this
convenient setting using the power of steam
Mixed Loads
Cottons
Delicates
Towels
Steam
Dewrinkle
Warm
Up
Bedding
Air Fluff
Casuals
Quick Dry
Damp Cool Down Complete
Estimated Time Remaining
High
More Dry
Medium
Dry
Low
Less Dry
Extra Low
Damp
Full Loads
Perm Press
Steam Dewrinkle - Stored or wrinkled clothes come out wrinkle-free with this helpful setting
that uses steam to refresh and dry a load of any size
Drying
Sheets
Bulky
No Heat
Time
Dry
Control
Clean Filter
Temp
Level
Add
Time
Ext Tumble
Wrinkle Care
Volume
Lock Controls
Hold 3 Sec
HE Sensor Dry - Takes the guesswork out of drying times by sensing the moisture in the drum
and drying accordingly
Stainless steel drum - Resists rust and helps protect clothes
Quick Dry - Quickly dries items and small loads for families on the go
Sanitize cycle - This option reduces certain types of bacteria by 99.8%
Damp Alert - Alerts you when clothes are the ideal dampness for ironing, for perfectly
wrinkle-free results
Extended Tumble - Tumble clothes without heat to help prevent creasing and wrinkling
Model GFD45GSSKWW – White
Model GFD45GSPKDG – Diamond Gray
GFD45ESSKWW GFD45GSSKWW
GFD45ESPKDG GFD45GSPKDG
Specification Revised 6/16