ZENITH SERIES SECTION F: TROUBLESHOOTING ELECTRONIC TROUBLESHOOTING QUICK REFERENCE component replacement: HEAD, FOOT, OR HI/LO MOTOR DOES NOT GO UP AND/OR DOWN: Note: If the staff control must be replaced, follow the instructions on page 30 to perform that operation. HEAD OR FOOT MOTOR DOES NOT FUNCTION: STAFF CONTROL DOES NOT FUNCTION: cord. 28 ZENITH SERIES HEAD AND FOOT DECK FUNCTION PROPERLY, BUT ONE OR BOTH HI/LO MOTORS DOES NOT: 2. Press Hand Control Pendant buttons only resynchronize mode. small amount. 5 seconds. If the problem continues, contact Technical Support at 770-368-4700. HI/LO (Head) HI/LO (Foot) HI/LO DOWN and FOOT DOWN Foot Head Control Cable Note that pressing and releasing malfunction, and if any other buttons are pressed, the system will leave the resynchronize mode and you will occurs. 29 ZENITH SERIES TROUBLESHOOTING — REPLACING THE STAFF CONTROL ! ALWAYS UNPLUG THE POWER CORD BEFORE PERFORMING MAINTENANCE ON THE BED. Staff Control Assembly (#2) Staff Control Bevel Screws Footboard with cutout (#2) Staff Control Bevel Screws (#1) Shroud Screws the large hole. (#4) (#3) (#5) the cutout on the step 2. IMPORTANT: Run a cable tie through the mounting tube end hole, loop the excess cable, run the cable tie around the looped cable, and pull tight to secure. Cut off excess cable tie. Single T-Cable foot end - White (“T” runs along either side of Seat Pan to attach Pendant Hand Control). Staff Control Cable female end Locking End Cap Important: 30
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021