Knaack 40 Installation instructions

Lock Box

INSTALLATION INSTRUCTIONS WATCHMAN® IV Lock System

TOOL REQUIRED - Ratchet Wrench with 1/2" Socket or 1/2" Combination Wrench

NOTE: This lock system is designed to be used with a MASTER LOCK®* No. 1, MASTER LOCK No. 5 or

AMERICAN LOCK®* No. 50, or an equivalent sized lock. If you are using a padlock not listed above, it is your responsibility to make sure the lock mechanism is working correctly. Padlocks must meet ALL requirements listed in Figure 1 or Figure 2.

1. Unbolt the padlock tab using a 1/2" socket or wrench. Install 5/16" x 3/4" Carriage Bolt into correct hole in Padlock

Tab, install Padlock shackle into Padlock tab then secure to Lock Box using Locking Nut. Do not close the doors.

(See Figure 1 or 2.)

Figure 1.

For Installation of

Master Lock No. 5, American Lock No. 50 or equivalent size

Shackle

3/8" dia.

more open or or less closed to 11/32" dia.

7/8" to

1-1/8"

Locking

Nut

2-1/4" max.

Padlock Tab

5/16" x 3/4"

Carr. Bolt

1-3/16 or more open

Locking

Nut

Figure 2.

For Installation of

Master Lock No. 1 or equivalent size

2-1/4" max.

15/16" or

less

closed

Lock

Box

Shackle

5/16" dia.

or less

7/8" to

1-1/8"

5/16" x 3/4"

Carr. Bolt

Padlock

Tab

Use round Hole for

3/8" dia. shackle

(Master No. 5,

American No. 50)

Use square Hole for 5/16" dia.

shackle

(Master No. 1)

NOTE: Carriage Bolt will seat into round hole when tightening Locking Nut.

GAS

EXPLOSIVES

E

S

B

L

M

A

F

L

A

M

GAS POWERED

EQUIPMENT

TANKS

SOLVENTS

•

Do not put fuels, flammables, explosives or hazardous materials inside these products.

•

Gasoline, solvents, gun powder or other munitions, dynamite, propane, acetylene or other such products can explode if stored inside these products.

•

Use these products ONLY for storing and transporting electric or hand tools and equipment, and other similar materials.

•

Failure to follow these warnings or modification or other uses of these products could result in death, serious injury or property damage.

DO NOT PAINT OVER OR REMOVE THIS DECAL

TEST THE FUNCTION OF YOUR PADLOCK

(If you have installed one of the padlocks listed above per the instructions, you do not have to perform this test.)

2. Keep all cabinet doors open, with the padlock in the open position , close only one of the doors. If the latch rod does not slide up enough for the door to close, the padlock you have installed is not acceptable. If the door does close, push the padlock into the locked position. Lift up on the latch rod knob and try to open the door. If the door opens the padlock you have installed is not acceptable.

- NOTICE -

Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or unintended use of this product.

If you have any questions, or need to replace this decal, please give us a call. Call Toll Free 1-800-456-7865

KNAACK® products are protected by one or more of the following patents or trademarks: U.S. - 945736, 4288134, 4290281, 4383721,

5076078, 1182980, 1182981, 1182982, 1182983, 1266140, 1517767, 1560477, 1897535, 2290111; Canada - 1176681, 280058, 280798,

281398, 283281; U.K. - 2172510, 2233036, 1390299, 1392022; Australia - 754069, 754070; N.Z. - 296048, 296050; other patents pending.

KNAACK MANUFACTURING COMPANY

420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014 815-459-6020

© 2001 Knaack Manufacturing Company

* MASTER LOCK® is a U.S. registered trademark of Master Lock

Company.

AMERICAN LOCK® is a U.S. registered trademark of American Lock

Company.

Rev. 4/01 Part No. 14-0010

DANGER