IMPORTANT: READ INSTRUCTIONS BEFORE STARTING INSTALLATION
INSTALLATION INSTRUCTIONS
1. Fully close sliding doors.
2. Locate strike(C) on edge of inner door(D) so that locking unit(A) is installed on lower edge of outer door(B) slipping tongue(E) fits
thru center hole of strike unit (C)as indicated.
3. Mark top and bottom holes for strike unit (C).
4. Using 1/8” drill bit, drill holes where marked and install strike unit with 2 self-tapping metal screws furnished. Drill only
enough to penetrate door frame skin. Do not touch glass with drill bit.
5. Locate locking unit on bottom edge of outer door(B) as described in step 2 and mark 3 holeson stationary half of locking
unit(A).
6. Drill three (3) holes and install locking unit as described in step 4.
NOTE: PART (A) SHOULD FIT SNUG AGAINST PART (C).
Barton Kramer, Inc.
Miami, Florida
PADLOCK
USE 0) )
LOCK S ;
No. 166 ¿ NU CK
E { -— 7
ADJUSTABLE q dil |
SLOTTED | TR RTT |
de A
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021