Vinyl Wainscot/Planking Instructions Install and level matching base board. Apply bead of paneling adhesive to the back of trim Nail trim into studs 16 inch on-center Cut plank to measured height. Apply bead(s) of paneling adhesive to the back of panel. Stick panel at wall placement into base groove, neatly place panel groove over adjacent panel’s tongue. Level panel to ensure vertical. Cap and level with matching chair rail. Apply bead of paneling adhesive to the back of trim Stick trim on top of panels, with grove for panels facing down Level trim to ensure horizontal Nail trim into studs 16 inch on-center Apply bead of caulk along top, inner edge of trim MAINTENANCE: Wipe with Damp cloth. Most household cleaners will not affect the finish; it is recommended to test cleaners in small unseen areas prior to using on entire surface. If painted, follow the paint manufacturer’s instructions for cleaning. Complete instructions are on back side of package labels.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project