Dirt Devil UD70230 Use and Care Manual

Below you will find brief information for vacuum cleaner. The vacuum cleaner is designed to provide a powerful and efficient cleaning experience, with features designed for both hard floor and carpet cleaning. It includes a removable dirt cup for easy emptying, a filter that can be cleaned with a simple tap, and a Power Brush Tool* for deep cleaning carpets and rugs.

PDF Download
Document
Dirt Devil Vacuum Cleaner Owner's Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Powerful suction
  • Removable dirt cup
  • Cleanable filter
  • Power Brush Tool*
  • Lightweight design
  • Easy to use

Frequently asked questions

Each time the dirt cup is emptied, the filter should be cleaned. Tap the filter firmly against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use, this will not affect the filter’s performance.) Do not brush the filter.

An internal thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates the cleaner will stop running. If this happens proceed as follows: Turn cleaner OFF and disconnect it from the electrical outlet. Empty dirt cup. Inspect the nozzle and bag inlet openings for any obstructions. Clear obstructions if present. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate and cleaning may continue. If the thermal protector continues to activate after following the above steps, your cleaner may need servicing.

To replace the belt, lay the cleaner flat and flip it over to expose the nozzle base. The base should lay flat and face up. To remove the nozzle guard, use Phillips screwdriver to remove the five (5) screws. Lift the nozzle guard off. Lift and remove the brushroll. Dispose of the old belt. Place the new belt in the area of the brushroll without bristles. Slide the belt onto the motorshaft. With the new belt in place, pull and slide the brushroll into the nozzle, making sure that the brushroll end caps are in the correct orientation. Rotate the brushroll manually to make sure the belt is properly aligned. Reattach the nozzle guard. Replace the five (5) screws to secure the nozzle guard.
Preparing document for printing…
0%