WATERPROOF BLUETOOTH
SHOWER SPEAKER
BTS-06
USER MANAL
Thank you for choosing our product. We hope you will enjoy it very much.
Safety instructions
Read this manual carefully before putting the appliance into operation and keep this manual for future reference.
Product overview
direct sunlight and sharp edges.
flames.
device. Risk of short circuit!
the device in an extremely dry climate.
contact an authorised specialist.
1. Turn on your mobile phone and activate
the Bluetooth function.
2. Search for Bluetooth devices. BTS-06
will show up.
3. Pair your device with BTS-06. If
password is needed, type in “0000".
After BTS-06 is paired with your
device, connect it to your device.
Tips:
Once this speaker is paired and connected to your mobile phone, next time when you switch on this speaker, it will connect to your mobile phone automatically as long as the Bluetooth in your mobile phone is on.
Button description
On/Off: To switch on or off the unit.
long press for turning down the
volume.
press for turning up the volume.
Phone: To pick up or hang up a phone
call
Troubleshooting
Symptoms Causes
Can not switch the speaker on
Battery empty
Solutions
Charge the battery
Unable to pair the speaker
Speaker is already switched on, and it is not in pairing mode.
Refer to the section of
“Pairing BTS-
06 to mobile phone or other device”
Technical Specifications
Bluetooth support: 3.0+EDR
Range: 10 meters
Transmitting frequency: 2.4G Hz
Power supply: DC5v/100-120mA
Battery: 3.7v 400mAh lithium
Charging time: approx. 3 hours
Operating time: approx. 6 hours
IP grade: IPx4
Unit weight: approx. 0.1kg
DC5v
Accessories included
1. USB charging cable
Charge Integrated Battery
This Bluetooth speaker is powered by integrated rechargeable lithium battery.
Charge the battery as follows:
1. Insert the charging cable into the DC
5V socket on the unit. Connect the USB
plug into a PC or AC/DC adaptor. The
LED indicator turns red and the battery
is being charged.
2. When the battery is fully charged, the
red LED indicator goes out.
Pairing BTS-06 to mobile phone or other device
Activate the Bluetooth speaker’s pairing mode by, when in power off mode, press and hold the on/off button for about 6 seconds until the red LED and blue LED are flashing alternatively. Now the speaker is ready for pairing.
Tips:
Please make sure the speaker is in power off mode when trying to activate the pairing mode.
Company: Shenzhen XinHuaMei Electronics Limited Company.
Name: Mini Bluetooth Speaker
Model Number: BTS-06
FCC ID: R8HBTS-06
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment。
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
