EcoSmart ECO 8 is an electric water heater that provides hot water for residential and light commercial applications. It features precise temperature control between 80°F - 125°F (26°C - 51°C), allowing you to customize your desired water temperature. With its compact size and wall-mounted design, the ECO 8 is ideal for space-constrained areas. It offers energy efficiency, cost savings, and a longer lifespan compared to traditional water heaters, making it an eco-friendly and economical choice for your hot water needs.
advertisement
QUICK INSTALL GUIDE
Models: Eco 8 - 11
This is a quick install reference guide, you must follow the complete installation instructions and homeowners manual included with the unit.
IMPORTANT SAFETY INFORMATION
As when installing or using any high voltage electrical appliance, basic safety precautions should always be followed.
Under no circumstances should you attempt to clean, install, inspect, repair, disassemble, or otherwise service this water heater without first shutting off all power to the unit directly at the breaker box. SERIOUS BODILY INJURY OR DEATH
COULD OCCUR IF YOU IGNORE THIS WARNING. THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN AND
PLUMBER IN ACCORDANCE WITH ALL NATIONAL, STATE, PROVINCIAL, AND LOCAL ELECTRICAL AND PLUMBING CODES.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY AND COMPLETELY BEFORE INSTALLATION AND BEFORE USE. FAILURE
TO DO SO COULD CAUSE PROPERTY DAMAGE OR SERIOUS PERSONAL INJURY OR DEATH, AND VOID YOUR WARRANTY.
THIS WATER HEATER MUST BE INSTALLED BY A LICENSED ELECTRICIAN AND PLUMBER PROOF OF INSTALLATION MUST
ACCOMPANY THE WARRANTY CARD.
Plumbing Connection
The Eco 8 - series is supplied with 1/2” NPT and
Eco 11 CF, DO NOT weld or use TEFLON tape or
PASTE. Water heater hoses are strongly recommended. Connect the COLD water supply line to the right side of the unit and the
HOT water line to the left side of the unit.
Electrical Connection
All units are supplied with (1) sets of wires and a ground. These wires must be installed to an independent double pole breakers as per MODEL specs below.
HOT WATER OUT COLD WATER IN
Check all wires to make sure they are securely fasten and tight. Before turning the power ON make sure the system has been flushed as required in the plumbing section. When the unit is powered up turn the control knob to turn ON the GREEN LED indicator light. You can set or adjust your temperature at any time between 80⁰F - 125⁰F (26⁰ - 51⁰).
Once both water lines are fastened and secured you MUST run water through the unit for at least
2 minutes to FLUSH any air pockets (purging) in the lines, it is recommended that all faucets, showers etc be run. Failure to follow this step can cause permanent damage to the unit. This procedure MUST be performed before any electrical power is turned on.
Installation Question
(877) 474-6473 [email protected]
Model
Eco 8
Eco 11
ELECTRICAL SPECIFICATIONS
Required
Breaker
Max Amp
Draw
1 x 40A DP 37
1 x 60A DP 57
AWG Cable
#08 / 1 set
#06 / 1 set
advertisement
Related manuals
advertisement