Scope : USER MANUAL TNCN Exe JUNCTION BOX Rev : H Date

Scope : USER MANUAL TNCN Exe JUNCTION BOX Rev : H Date
Scope :
USER MANUAL TNCN Exe JUNCTION BOX
Rev :
H
Date :
30.08.2013
Marking
Handling
Checked by :
E.T.
Approved by :
S.Gr.
Page :
1 of 1
Doc. no. :
51-CNX-5
A certification label is attached to the box, ref. Fig 1.
Precautions have to be taken to avoid damages to the equipment and the individual. The enclosure to be
packed such that no damage will occure during shipping.
Installation/
Dismantling
When mounting the enclosure ensure that there is no damages, especially inspect the gasket and cover of
the equipment. Installation to be performed in accordance with standard 60079-14 ( NEK 420 ) and/or the
requirements for the actual installation site.
NOTE !
Always read the requirements in the certificate.
NOTE !
When plastic window is mounted in the box, the box to carry a warning label.
Text : WARNING – POTENTIAL ELECTROSTATIC CHARGING HAZARD – SEE INSTRUCTIONS
Instructions : cleaning window with soap and water only.
The size of entries are from 16 to 100 mm free hole and the quantity is as many as physical possible
on the side, lid, back or bottom / top of the enclosure. Ensure that there is enough space for the
planned cable gland to be mounted and that the gland / entrie do not come in conflict with essential
parts inside the enclosure.
Installation of terminals and drilling of new entries only to be performed by skilled persons.
Label to be marked with maximum voltage and amp rating. Check certificate that installation is
within the requirements in the certificate.
Do not connect the box to power source before installation is completed, dielectric strength test is
performed and lid mounted on box.
When removing the enclosure, the same precautions apply as those observed when mounting the
enclosure.
Lifting lugs
If the box is equipped with removable lifting lugs, these have – after completed installation - to be removed
and replaced with an Ex-approved sealing kit, which is to be supplied by BARTEC TECHNOR.
Inspection /
Maintenance
TNCN enclosures is made of acid resistant stainless steel and thereof not subject to corrosion.
We recommend that maintenance is performed in accordance with the IEC 60079-17/60079-7/60079-11
standards ( NEK 420 ).
If any damages is found, the enclosure should be put out of service and the manufacturer contacted.
Further technical informations is available on www.bartec.no
Fig.1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement