User manual | Catalog ST 70 · 2013

SIMATIC S7-1500
© Siemens AG 2013
Power supplies
System power supplies
■ Overview
• Power supplies for the SIMATIC S7-1500
• For conversion of AC or DC line voltages to the operating
voltages required for the internal electronics
• 25 or 60 W output power
• Can be used for S7-1500 or ET 200MP
• Configuration via STEP 7 V12
4
■ Technical specifications
6ES7 505-0KA00-0AB0
PS 25W 24VDC
6ES7 505-0RA00-0AB0
PS 60W 24/48/60V DC
6ES7 507-0RA00-0AB0
PS 60W 120/230V AC/DC
E01
E01
E01
V12.0 / V12.0
V12.0 / V12.0
V12.0 / V12.0
FH technology
Redundancy
• Redundant capability
- for increased power
Yes
Yes
Yes
Yes
Yes
Yes
Supply voltage
Rated voltage/DC
24 V; SELV
permissible range, lower limit (DC)
Static 19.2 V, dynamic 18.5 V
Static 19.2 V, dynamic 18.5 V
88 V
permissible range, upper limit (DC)
Static 28.8 V, dynamic 30.2 V
Static 72 V, dynamic 75.5 V
300 V
General information
Hardware product version
Engineering with
• STEP 7 TIA Portal can be configured/
integrated as of version
permissible range, lower limit (AC)
85 V
264 V
permissible range, upper limit (AC)
Reverse polarity protection
Yes
Yes
Short-circuit protection
Yes
Yes
Line frequency
• Rated value 50 Hz
• Frequency of the supply voltage
• Frequency of the supply voltage
Mains buffering
• Mains buffering time
Yes
Yes
47 Hz
63 Hz
20 ms
20 ms
Input current
Rated value at 48 V DC
1.5 A
Rated value at 60 V DC
1.2 A
20 ms
Rated value at 120 V DC
0.6 A
Rated value at 230 V DC
0.3 A
Rated value at 120 V AC
0.6 A
Rated value at 230 V AC
0.34 A
Output current
Short-circuit protection
4/48
Siemens ST 70 · 2013
Yes
Yes
Yes
© Siemens AG 2013
SIMATIC S7-1500
Power supplies
System power supplies
■ Technical specifications (continued)
6ES7 505-0KA00-0AB0
PS 25W 24VDC
6ES7 505-0RA00-0AB0
PS 60W 24/48/60V DC
6ES7 507-0RA00-0AB0
PS 60W 120/230V AC/DC
Power
Infeed power to the backplane bus
25 W
60 W
60 W
Power losses
Power loss at nominal rating conditions
6.2 W
12 W
12 W
Interrupts/diagnostics/status
information
Status indicator
Yes
Yes
Yes
Galvanic isolation
primary/secondary
Yes
Yes
Yes
Isolation
Isolation checked with
707 V DC (type test)
Yes
Yes
Yes
Degree and class of protection
Protection class
3; with protective conductor
1; with protective conductor
1; with protective conductor
Dimensions
Width
35 mm
70 mm
70 mm
Height
147 mm
147 mm
147 mm
Depth
129 mm
129 mm
129 mm
Weight
Weight, approx.
350 g
600 g
600 g
EMC
Surge immunity
• on the supply lines acc. to
IEC 61000-4-5
■ Ordering data
Order No.
Order No.
Power supply
Accessories
For supplying the backplane bus of
the S7-1500
SIMATIC S7-1500 mounting rail
24 V DC input voltage, power 25 W
6ES7 505-0KA00-0AB0
24/48/60 V DC input voltage,
power 60 W
6ES7 505-0RA00-0AB0
120/230 V AC input voltage,
power 60 W
6ES7 507-0RA00-0AB0
4
Fixed lengths, with grounding
elements
• 160 mm
• 482 mm
• 530 mm
• 830 mm
6ES7 590-1AB60-0AA0
6ES7 590-1AE80-0AA0
6ES7 590-1AF30-0AA0
6ES7 590-1AJ30-0AA0
For cutting to length by customer,
without drill holes; grounding elements must be ordered separately
• 2000 mm
6ES7 590-1BC00-0AA0
PE connection element for
mounting rail 2000 mm
6ES7 590-5AA00-0AA0
Spare part, 20 units
Power connector
6ES7 590-8AA00-0AA0
With coding element for power
supply module; spare part, 10 units
Siemens ST 70 · 2013
4/49
© Siemens AG 2013
SIMATIC S7-1500
Power supplies
Load power supplies
■ Application
The design and functionality of the SIMATIC PM 1507 singlephase load power supply (PM = power module) with automatic
range selection of the input voltage are an optimal match to the
SIMATIC S7-1500 PLC. It supplies the S7-1500 system components such as CPU, system power supply (PS), I/O circuits of the
input and output modules and, if necessary, the sensors and
actuators with 24 V DC.
4
■ Technical specifications
Order No.
6EP1 3324BA00
6EP1 3334BA00
Order No.
6EP1 3324BA00
6EP1 3334BA00
Product
S7-1500
PM1507
S7-1500
PM1507
Product
S7-1500
PM1507
S7-1500
PM1507
Power supply, type
24 V/3 A
24 V/8 A
Power supply, type
24 V/3 A
24 V/8 A
Controlled, isolated DC voltage
24 V
1%
0.1 %
0.1 %
50 mV
Controlled, isolated DC voltage
24 V
1%
0.1 %
0.1 %
50 mV
150 mV
150 mV
No
No
LED green for
24 V O.K.;
LED red for fault;
LED yellow for
stand-by
LED green for
24 V O.K.;
LED red for fault;
LED yellow for
stand-by
No overshoot of
Uout (soft start)
1.5 s
10 ms
3A
0…3A
72 W
12 A
No overshoot of
Uout (soft start)
1.5 s
10 ms
8A
0…8A
192 W
35 A
70 ms
70 ms
12 A
35 A
70 ms
70 ms
Input
Output
Input
1-phase AC
1-phase AC
120 V
230 V
Automatic range
selection
120 V
230 V
Automatic range
selection
85 … 132 V
170 … 264 V
85 … 132 V
170 … 264 V
Mains buffering at lout rated, min.
Mains buffering
2.3 x Uin rated,
1.3 ms
20 ms
at Uin = 93/187 V
2.3 x Uin rated,
1.3 ms
20 ms
at Uin = 93/187 V
Rated line frequency
•1
•2
50 Hz
60 Hz
50 Hz
60 Hz
Line frequency range
45 … 65 Hz
45 … 65 Hz
1.4 A
3.7 A
0.8 A
1.7 A
23 A
62 A
1.3 A²·s
T 3.15 A/250 V
(not accessible)
Recommended
miniature circuit
breaker: 10 A,
characteristic B
or 6 A, characteristic C
12 A²·s
T 6.3 A/250 V
(not accessible)
Recommended
miniature circuit
breaker: 16 A,
characteristic B
or 10 A, characteristic C
Supply voltage
• 1 for AC rated value
• 2 for AC rated value
• Note
Input voltage
• 1 for AC
• 2 for AC
Overvoltage strength
Input current
• at rated value of input voltage 120 V
rated value
• at rated value of input voltage 230 V
rated value
Switch-on current limitation (+ 25 °C),
max.
I²t, max.
Built-in input fuse
Protection in the supply feeder
(IEC 898)
4/50
Siemens ST 70 · 2013
Output
Rated voltage Uout rated DC
Total tolerance, static ±
Static mains compensation, approx.
Static load compensation, approx.
Residual ripple, peak-peak, max.
Residual ripple, peak-peak, typ.
Spikes peak-peak, max.
(bandwidth approx. 20 MHz)
Product function: output voltage is
adjustable
Status display
Signaling
On/Off behavior
Startup delay, max.
Voltage rise, typ.
Rated current Iout rated
Current range
typical active power output
short-term overload current in the
event of a short circuit during startup,
typical
Duration of the overload capability
overcurrent in the event of a short
circuit during startup
short-term overload current in the
event of a short circuit during operation, typical
Duration of the overload capability
overcurrent in the event of a short
circuit during operation
© Siemens AG 2013
SIMATIC S7-1500
Power supplies
Load power supplies
■ Technical specifications (continued)
Order No.
6EP1 3324BA00
6EP1 3334BA00
Order No.
6EP1 3324BA00
6EP1 3334BA00
Product
S7-1500
PM1507
S7-1500
PM1507
Product
S7-1500
PM1507
S7-1500
PM1507
Power supply, type
24 V/3 A
24 V/8 A
Power supply, type
24 V/3 A
24 V/8 A
Parallel switching for enhanced
performance
Note
Yes
Yes
EMC
Parallel connection of 3 A and
8 A possible;
devices must be
activated simultaneously, at
I load max. 75 %
per device
2
Parallel connection of 3 A and
8 A possible;
devices must be
activated simultaneously, at
I load max. 75 %
per device
2
EN 55022
Class B
EN 61000-3-2
EN 61000-6-2
EN 55022
Class B
EN 61000-3-2
EN 61000-6-2
0 … 60 °C
with natural
convection
0 … 60 °C
with natural
convection
-40 … +85 °C
-40 … +85 °C
-40 … +85 °C
-40 … +85 °C
Climate class
3K3, without
condensation
Climate class
3K3, without
condensation
Screw/springtype connection
technology
Screw/springtype connection
technology
L, N, PE: 1 screw
terminal each for
0.5 ... 2.5 mm²
L+, M:
2 screw terminals
each for
0.5 ... 2.5 mm²
L, N, PE: 1 screw
terminal each for
0.5 ... 2.5 mm²
L+, M:
2 screw terminals
each for
0.5 ... 2.5 mm²
50 mm
147 mm
129 mm
50 mm
205 mm
0.45 kg
Yes
75 mm
147 mm
129 mm
75 mm
205 mm
0.74 kg
Yes
No
No
No
No
No
No
Number of devices that can be
switched in parallel to increase
performance, units
Efficiency
Efficiency at Uout rated, lout rated,
approx.
Power loss at Uout rated, lout rated,
approx.
87 %
90 %
11 W
21 W
0.1 %
0.1 %
1%
2%
5 ms
5 ms
Closed-loop control
Dynamic mains compensation
(Uin rated ±15 %), max.
Dynamic load compensation
(lout: 50/100/50 %), Uout ± typ.
Setting time, maximum
Response value current limitation
• minimum
• maximum
additional control
loop, differentiation (closed-loop
control) at
< 28.8 V
additional control
loop, differentiation (closed-loop
control) at
< 28.8 V
8.4 A
9.6 A
3.4 A
Yes
9A
Yes
electronic shutdown, automatic
restart
Electronic shutdown, automatic
restart
Protection class
Yes
Safety extra-low
output voltage
Uout acc. to
EN 60950-1 and
EN 50178 and
EN 61131-2
Class I
Yes
Safety extra-low
output voltage
Uout acc. to
EN 60950-1 and
EN 50178 and
EN 61131-2
Class I
Leakage current
• maximum
• typical
3.5 mA
0.4 mA
3.5 mA
1.3 mA
CE marking
UL/cUL (CSA) approval
Explosion protection
CB approval
Degree of protection (EN 60529)
Yes
Available soon
Available soon
Yes
IP20
Yes
Available soon
Available soon
Yes
IP20
Security
Primary/secondary isolation
Electrical isolation
4
Operating data
Ambient temperature
• during operation
- Note
Ambient temperature
• during transport
• during storage
Humidity class according to EN 60721
Connections
Connections
• Supply input
• Output
• Auxiliary contacts
3.15 A
3.6 A
Current limitation, typ.
Property of the output,
short-circuit-proof
Short-circuit protection
Supply harmonics limitation
Noise immunity
Mechanical system
Protection and monitoring
Output overvoltage protection
Emitted interference
Width of enclosure
Height of enclosure
Depth of enclosure
Mounting width
Mounting height
Weight, approx.
Product property of the enclosure:
side-by-side enclosure
Type of mounting
• Wall mounting
• DIN rail mounting
• S7-300 rail mounting
Installation
■ Ordering data
can be mounted can be mounted
onto S7-1500 rail onto S7-1500 rail
Order No.
SIMATIC S7-1500 PM 1507
Input 120/230 V AC,
output 24 V DC, 3 A
6EP1 332-4BA00
Input 120/230 V AC,
output 24 V DC, 8 A
6EP1 333-4BA00
Siemens ST 70 · 2013
4/51

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project