Sony CX730 RC controlled CAM Instruction manual
Below you will find brief information for RC controlled CAM CX730. This document describes how to connect a Sony CX730 camera to an Arduino-based platform for remote control using the LANC interface. This allows you to control functionalities like recording, zooming, and camera on/off through the Arduino platform. The document describes the wiring diagram for the 10-pin LANC plug, provides details on controlling camera functions, and mentions the use of specific Arduino ports for camera commands.
Advertisement
Advertisement
Advertisement
Key features
- Arduino control
- LANC interface
- Remote control
- Recording control
- Zoom control
- Camera on/off
Frequently asked questions
You can conect camera to arduino by wiring LANC interface pins of camera to Arduino platform. Instruction manual provides wiring diagram and description of each pin
Ports 13 and 14 are used for camera control.
You can control recording, zooming, and camera on/off remotely.
Connect pin 7 with a 100k ohm resistor to GND (pin 3) to activate video out on pin 9.