Carvin BX 500 Bass Amplifier User Manual

Below you will find brief information for Bass Amplifier BX 500. The Carvin BX 500 Bass Amplifier offers a boutique flat response with high headroom for any bass type. Features include 4 discrete class A input stages, a 12AX7 preamp tube with a bypass switch, 2 mids sweep semi-parametric EQ, a 9-band graphic EQ with front panel switch or by the optional FS22 footswitch, a single knob compressor, an effects loop, a tuner output jack independent of the mute switch, a direct out balanced XLR with front panel level and a switchable ground lift for AC ground isolation.

PDF Download
Document
Carvin BX 500 Bass Amplifier User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Four discrete Class A input stages
  • 12AX7 preamp tube with a bypass switch
  • 2 mids sweep semi-parametric EQ
  • 9-band graphic EQ
  • single knob compressor
  • Effects loop
  • Tuner output jack independent of mute switch
  • Direct out balanced XLR with front panel level
  • Switchable ground lift for AC ground isolation

Frequently asked questions

The BX500 delivers 300w at 8 ohms, 500w at 4 ohms, and 500w at 2 ohms (with the 2 ohm switch engaged).

The BX500 features a contour control, treble and bass tone controls, 2 semi-parametric mid sweep tone controls, a 9-band graphic EQ, and a drive control.

The 2 ohm switch allows the BX500 to operate with speaker loads down to 2 ohms. Set this switch to the IN position if the total impedance of all speakers connected is less than 4 ohms.
Preparing document for printing…
0%