Blue Power battery charger

Blue Power battery charger
Blue Power battery charger
__________________________________________________________________
Blue Power Battery Charger IP 20
Universal input: 90-265 VAC or 90-350 VDC
The charger will operate on whatever supply is available.
Adaptive 4-stage charge characteristic: bulk – absorption – float – storage
The Blue Power charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’
feature will automatically optimise the charging process relative to the way the battery is being used.
Less maintenance and aging when the battery is not in use: the Storage Mode
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the
storage mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion
of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery.
This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.
Protected against overheating and silent fan cooling
Output current will reduce as temperature increases up to 60°C, but the Blue Power charger will not fail.
The load and temperature controlled fan is practically inaudible
Two LED’s for status indication
Yellow LED: battery being charged
Green LED: float charge, the battery is charged
Learn more about batteries and battery charging
To learn more about batteries and charging batteries, please refer to our book ‘Energy Unlimited’ (available free
of charge from Victron Energy and downloadable from www.victronenergy.com).
Blue Power charger IP 20
Input voltage range
12/7
12/10
12/15
24/5
24/8
90-265 VAC or 90-350 VDC
Frequency)
Charge voltage 'absorption' (V DC)
Charge voltage 'float' (V DC)
Charge voltage 'storage' (V DC)
Charge current (A)
45-65 Hz or DC
14,4
28,8
14
28
13,2
26,4
7 / 10 / 15
5/8
4-stage adaptive
Charge characteristic
Minimum battery capacity (Ah)
24 / 36 / 55
16 / 24
Can be used as power supply
√
√
Protection
Operating temp. range
Battery reverse polarity (fuse in battery cable)
Output short circuit Over temperature
-20 to +60°C (full rated output up to 40°C)
Humidity (non condensing)
Max 95 %
ENCLOSURE
Material & Colour
Battery-connection
230 V AC-connection (3)
aluminium (blue RAL 5012)
Black and red cable of 1,5 meter
Cable of 1,5 meter with Europe class 1 plug (CE certified)
Protection category
Weight (kg)
Dimensions (h x w x d in mm)
IP 20
1,3
1,3
50 x 85 x 200
50 x 85 x 200
STANDARDS
Safety
EN 60335-1, EN 60335-2-29
Emission
EN 55014-1, EN 61000-3-2
Immunity
EN 55014-2, EN 61000-3-3
Victron Energy B.V. / De Paal 35 / 1351 JG ALMERE / The Netherlands
Phone: (+31) (0)36 535 97 00 / Fax: (+31) (0)36 535 97 40 / www.victronenergy.com / e-mail: [email protected]
Blue Power battery charger
__________________________________________________________________
Blue Power Battery Charger Waterproof
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Blue Power charger. The casing is made of cast aluminium and the
electronics are molded in resin.
Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature
increases up to 60°C, but the Blue Power charger will not fail.
Automatic three stage charging
Once the absorption voltage has been reached, the Blue Power charger will switch to float charge after the
charge current has reduced to a low break point current (see specifications), or after a 20 hour absorption
period. The battery is therefore effectively protected against overcharging and can remain permanentely
connected to the charger. The charger will automatically reset and start a new charge cycle after interruption of
the AC supply.
Two LED’s for status indication
Yellow LED: battery being charged
Green LED: float charge, the battery is charged
Learn more about batteries and battery charging
To learn more about batteries and charging batteries, please refer to our book ‘Energy Unlimited’ (available free
of charge from Victron Energy and downloadable from www.victronenergy.com).
Blue Power charger Waterproof
12/6
12/15
Input voltage range (V AC)
24/3
24/8
28,8
200-265
Frequency (Hz)
45-65
Charge voltage 'absorption' (V DC)
14,4
14,4
28,8
Charge voltage 'float' (V DC)
13,6
13,6
27,2
15
27,2
Charge current (A)
6
3
Charge characteristic
3 stage with max. 20 hours absorption time
(2)
8
(2)
Minimum battery capacity (Ah)
12
24
6
16
Breakpoint current (A)
0,6
0,8
0,6
0,8
√
√
√
√
Can be used as power supply
Protection (1)
Operating temp. range
a,b,c,
-20 to +60°C (full rated output up to 40°C)
Humidity
Up to 100 %
ENCLOSURE
Material & Colour
aluminium (blue RAL 5012)
Battery-connection
230 V AC-connection (3)
Black and red cable of 1,5 meter
Cable of 1,5 meter with Europe class 1 plug (CE certified)
Protection category
Weight (kg)
Dimensions (h x w x d in mm)
IP 65
0,9
1.85
0,9
1.85
36 x 80 x 155
46 x 99 x 193
36 x 80 x 155
46 x 99 x 193
STANDARDS
Safety
EN 60335-1, EN 60335-2-29
Emission
EN 55014-1, EN 61000-3-2
Immunity
1) Protection
a. Battery reverse polarity (fuse in battery
cable)
b. Output short circuit
c. Over temperature
EN 55014-2, EN 61000-3-3
2) Forced cooling required for continuous full rated
output
3) Other plug types on request
Victron Energy B.V. / De Paal 35 / 1351 JG ALMERE / The Netherlands
Phone: (+31) (0)36 535 97 00 / Fax: (+31) (0)36 535 97 40 / www.victronenergy.com / e-mail: [email protected]
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement