User Manual

User Manual
User Manual
y
y
y
y
There are no user serviceable parts inside.
Qualified personnel should do Service only.
Do not touch any wires during operation.
Do not touch the unit barehanded during operation.
B. Installation
You can install the unit on the truss or ceiling. Use clamps to fix the unit to truss.
Always ensure that the unit is firmly fixed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attaching the unit is
secure. Also always use a safety cable that can hold 10 times of the weight of the unit
when installing the fixture.
LED-130
Please read this user manual carefully and follow the instructions to avoid danger or
damage to the unit due to mishandling.
A. Safety Introductions
y Please keep this User Manual for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
y Unpack and check carefully there is no transportation damage before using the unit.
y Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
y It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
y The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
y Disconnect mains power before replacement or servicing.
y Replace only with the same type.
y Make sure there are not flammable materials close to the unit while operating, as it is
fire hazard.
y Use safety cable when fixes this unit.
y In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repair carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center and
always use the same type spare parts.
Warnings
y Always remember to unplug the unit from the main power before any service is done.
C. Technical Specification
Voltage: 120V~60Hz 230/240/250V~50Hz
LED: 1 x 10W White
Fuse: T 6.3A
Dimension: 272 x 250 x 112 mm
Weight: 4kgs
D. Operation
Set switch to
mode, gobo wheel and glass roller rotation;
Set switch to
mode, gobo wheel rotation;
Set switch to
mode, the unit run to music.
E. Focus Adjustment
Unscrew the screw and move the arm forward or
backward to adjust the focus.
F. Troubleshooting
The fixture does not work
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check microphone to see if it is good by tapping the microphone.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement