MINI M002RGB Laser Display System User's Manual

R

MINI Laser Display System User's Manual

Big Dipper

Packing list

While receiving the product, please take carefully and check whether it was been destroyed on conveyance. After that, check the following parts.

1.1×Laser Unit.

2.1×A dapter 3.1×User Manual

Installation guide

1.

Be sure that there is no frammable or explosive objects at the arrange of 1.5 meters leastways, while installation. Keep 0.5 meter away from wall at least.

2.

Before installation ,please make sure the power voltage matches the system rated

3.

voltage.

The equipment should be fixed firmly ,prevent the light from shocking or striking fiercely

Safety guide

1.

The unit is the class 3B laser produst.

2.

3.

Must be operate according to the manual do not disassemble the lamps yourself ,if there is any problem , please contact with the professional

The product should be installed immovably

.

by professional technicion.

4.

The system should be kept dry .Please don't use the system in the condition of rain ,wet or dust.Need

waterproof equipment in the open air.

5.

Do not turn on or off the system frequently, and avoid keeping it working for a long time.

6.

Prevent outer dangerous objects into the system, or there will be malfunction.

7.

The system should be keep 1m far away from the objects shined at least.

8.

9.

When transport the system again, please use the original package to avoid shaking.

Keep the unit far away from other A class high voltage flash objects.

10.

Do not look at the light directly.

Technical Parameters

Model

Parameters

Input power

Sanner angle

Laser power

Function

Dimensions

N.W.

M002RGB

DC12V , 1A

R ≥ 50mW G ≥ 4mW B ≥ 80mW

Sound control, Auto control, strobe control, he external potentiometer can adjust sound sensitivity, strobe speed, grating rotation speed.

160*136*101mm

Backboard sketch map

1 2 3 4 5 6

1. Segment switch: Change working mode. 2.DC 5V

:

Input power.

3. Sound sensitivity adjustment control knob. 4.Auto: Auto strobe control knob.

5.Motor Speed: Speed adjustment control knob of the motor. 6.MIC: Voice signal receiver.

Installation

Laser light above MPE should not be accessible to audience, MPE can't be exceed in the separation distance, see the illustration:

Public Access(Balcony etc)

2.5 metre Horizontal

BEAMS

MPE must not be exceeded

LASER

LASER BEAMS

3 metre Height MPE must not be exceeded

MPE must not be exceeded

2.5 metre Horizontal

Side view - showing the 3m vertical separation distance

Public Access(Balcony etc)

Plan View-showing the 2.5m horizontal separation distance

Diagram illustration

Big Dipper Laser Science And Technology Co., Ltd

All products made from Big Dipper Laser Company have anti - fake identification. please verify the anti-counterfeit label at the bottom of the case to ensure the interests of consumers.