Do not attempt to service this video product by yourself, as taking

Do not attempt to service this video product by yourself, as taking
4-In-1 Camera
(CVI/TVI/AHD/Analog)
Infrared Bullet
► 2 Megapixel (1080P) HD
► Day & Night
► Weatherproof (Indoor/Outdoor)
Zoom & Focus Adjustment
Output Control: (Black spot is position of dip switch.)
ON
1
► Do not attempt to service this video product by
yourself, as taking apart the camera may expose
you to dangerous voltage or other hazards.
ON
2
CVBS
1
2
CVI
ON
ON
1
2
TVI
1
2
AHD
► Please comply with all electrical safety
standards during installation and operation.
Image Sensor
Frame Rate
Signal System
Horizontal Resolution
IR LED
IR Distance
Minimum Illumination
Electronic Shutter Speed
S/N Ratio
Lens
Day/Night
Weatherproof Rating
Video Output
Power Consumption
Power Supply
Camera Dimensions
1/2.7” 2 Megapixel CMOS
30fps @ 1080P
NTSC
1920 (H) x 1080 (V)
42 Pieces (850nm)
150ft Depending on Scene Reflectance
0 Lux (with IRs ON)
1/60 ~ 1/30,000 Seconds (Auto)
More Than 50dB
2.8-12mm Vari-focal Lens
Auto (Built-in ICR)
IP66
1.0Vp-p, 75Ω Composite BNC
Less Than 4 Watts
DC 12 Volt ± 10%
3.19” (Max Height) x 11.1” (Max Length)
► In order to prevent damage caused by fire or
electrical shock, please do not submerge camera
in water or expose any open parts to liquid.
► Do not expose the lens directly to the sun or to
strong light as this may damage the image sensor.
► There are some sophisticated parts inside this
camera, therefore always handle with care in
order to avoid any internal damages to the
camera.
► Make sure to use the appropriate power supply
and that the power is plugged into the camera
correctly and securely. Do not switch on power
until after the camera connection is complete.
NO VIDEO OUTPUT:
► Check the power cable to the power box or wall outlet. Make
sure the power connections are secure.
► If you are using a multiple output power box, make sure the
power switch is in the “ON” position and that all fuses are
illuminated.
► If you are using a multiple output power box, make sure the
POSITIVE (+) and NEGATIVE (-) wires are properly connected.
► Check the BNC video cable running from the camera to the
video input on the DVR or display. If you are using pre-made
cable, make sure the BNC connectons are secure. If you are
using a spool of cable (RG59), make sure the outer copper wire
is not touching the center pin when fitting the cable ends with
BNC connectors.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement