Seip TM80 Electric Garage Door Operator Garage Door Opener Operating Instructions

Seip TM80 Electric Garage Door Operator Garage Door Opener Operating Instructions

The Seip TM80 Electric Garage Door Opener provides secure and convenient operation for your garage door. The unit features a wall-mounted push-button and remote control key fob for easy operation. A courtesy lamp illuminates automatically and can be used to signal the door's position. In case of power failure, the door can be released manually. The system is designed for longevity and requires minimal maintenance. Additional keyfobs can be registered for convenience.

advertisement

Assistant Bot

Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.

Seip TM80 Electric Garage Door Operator Operating Instructions | Manualzz

OPERATING INSTRUCTIONS

Seip TM80 Electric Garage Door Operator

Press the wall mounted push-button or remote control key-fob button for half a second to start the motor, the courtesy light will illuminate automatically and extinguish a few minutes after the motor was last used. further use of the push-button can be used to stop the door during motion, and change the direction of travel.

IN THE EVENT OF A POWER FAILURE

Your door can be released from the motor and operated manually by pulling the RED MANUAL RELEASE

CORD inside the garage while pushing the door out from the bottom, detailed instructions will be found on a label on the back of the door. If your garage has no alternative pedestrian access the original locking door handle can allow manual operation of your door from outside. The key to this locking handle should be labelled "garage door emergency release key" and kept in a safe place. (not in the garage)

OPERATING THE UNIT AFTER MANUAL OPERATION DURING POWER FAILURE

To restore normal motorised operation, close the door then start the motor.

MAINTENANCE

The remote control transmitters are powered by a battery with a life expectancy of two years, the mini keyfob takes two CR1616 "coin" type cells, four button midi keyfob uses one CR2032 battery. The courtesy lamp is an

E14 screw fitting 45mm golf-ball type bulb, easily accessible behind the plastic diffuser cover. (40 Watt Max)

Your Seip electric operator should not require any maintenance for ten years but in order to keep the installation in good working order the moving parts on the door should be lubricated at 12 month intervals.

REGISTERING AN ADDITIONAL KEYFOB TRANSMITTER

Take an existing registered keyfob & use it to close the door, then within five seconds of closing the door, hold both keyfob buttons down simultaneously for five seconds until the courtesy lamp starts flashing, (on a four channel midi keyfob use the upper two buttons) Now take the new keyfob and press the button you wish to use to operate the door, the light will stop flashing when the new fob is registered, repeat as above for further keyfobs.

YOUR GUARANTEE

The manufacturers guarantee on your Seip electric door operator covers all parts for five years. This guarantee does not cover light bulbs or batteries. If you have any problems with your Seip electric door operator, please contact Amourelle Ltd for assistance.

Amourelle Products Ltd

8 Ambleside Close

Woodley, Reading

Berkshire. RG5 4JJ.

Phone 0118 969 4657 [email protected]

Registered in England No. 1640847 VAT No. 642 0832 61

Registered Office 10 Beech Court, Wokingham Rd, Hurst, Berks. RG10 5RQ

advertisement

Key Features

  • Wall-mounted push-button
  • Remote control key fob
  • Courtesy lamp
  • Manual release cord
  • Power failure operation
  • Low maintenance
  • 5-year warranty

Frequently Answers and Questions

How do I register an additional key fob?
To register a new key fob, close the door using an existing registered key fob, then within 5 seconds of the door closing, hold both key fob buttons down simultaneously for 5 seconds until the courtesy lamp starts flashing. Then, press the button on the new key fob that you want to use to operate the door. The light will stop flashing when the new key fob is registered. Repeat this process for further key fobs.
What type of batteries are used in the remote control transmitters?
The mini key fob uses two CR1616 "coin" type cells, while the four-button midi key fob uses one CR2032 battery. The remote control transmitters have a battery life expectancy of two years.
What kind of light bulb is used in the courtesy lamp?
The courtesy lamp is an E14 screw fitting 45mm golf-ball type bulb, with a maximum wattage of 40 watts. It is easily accessible behind the plastic diffuser cover.

Related manuals

Download PDF

advertisement