Carpet Protection Tape – User Guide

Carpet Protection Tape – User Guide
Carpet Protection Tape – User Guide








Always lay the material on a small non critical area first to test for suitability
Not recommended to be left in place for more than 2 weeks, remove old film and
replace if necessary where lengthy projects are involved
Film is one time use only, remove and dispose of in accordance with local
environmental regulations
Various ambient and traffic conditions may affect the performance of the film, i.e.
excessive wear (eg doorways), direct sunlight & intense heat
Do not apply film over newly laid carpets where installed using a glue or
adhesive. The area should be ventilated for up to 72 hours to allow any vapours to
dissipate prior to application
Do not apply film if carpet or surface is damp. Rising moisture vapour from
cleaning or from uncured concrete floor surfaces is prevented from escaping and
may cause discoloration of carpet fibres
Do not apply to hard surfaces, such as ceramic tile, hardwood, linoleum, vinyl
flooring and marble
Not suitable for use on rugs, loose fitting carpet tiles or worn carpets
The product should be stored and used in ambient conditions, ideally at room
temperature for 24 hours prior to installation.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement