MAINTENANCE AND STORAGE: TROUBLESHOOTING

MAINTENANCE AND STORAGE: TROUBLESHOOTING
When laundrying, non-clothing cling to the protective
net or in the body. Non-baking bulky clothing, laundry
guarded to avoid danger.
The appliance shall not be used as a stool.
May cause a fire because the heater is winged cap or
incorrectly placed, it should not be used with a
program that can automatically power on, timer, or
other device to the heater.
This product is forbidden to use in inflammable and
explosive materials , and the use of ambient
temperature should not exceed 30℃. leave combustible
material at least 50 cm, to prevent fires.
Must ensure that the appliance is disconnected from
the power when power outage or moving this appliance.
Heater surface dirt, use a soft cloth moistened with
soap to wipe. Do not use organic solvents such as
gasoline, alcohol, prohibited the liquid from
entering the inside of the product. Not use in hot,
humid, dusty or volatile acid-base oil place.
高
湿
油
度
酸
Before use ,please check the power cord and plug is
damaged or not, the power cord do not bend, pull, in
order to avoid poor contact。unable to be tilted more
than 10 degree or down to the ground to use. Should be
placed on a flat plane.
Never touch the burning window so as not to burn. to
avoid overheating, Do not cover the heater.
Leave or when unused for long periods of time, be
sure to cut off the power, unplug the power cord.
The heater fire protective net is used to prevent
direct contact with the heating element when the
heater is used, the fire protective net must be
installed in place. Fire protective net not provide
comprehensive protection of children and the
disabled.
Turn off the power, not the cord, befor you pull the
power plug,otherwise it will cause a
short circuit, fire,electric shock.
Do not pull the power plug with wet hands.
in the risk of electric shock.
May not be used in surrounding of the tub,
sprinklers ,shower,bath or swimming pool.
Not the heater be placed directly below the power
outlet.
When heating, the absolute prohibition of the hands
or foreign objects into the body, can cause injury
or damage. Pay special attention to children .
Children should be supervised to ensure that they will
not be playing with the appliance.
This appliance is not intended to be physical, sensory
or mental defects, or lack of experience and common
sense people (including children), unless there is a
safeguard and responsible supervision
Never use in curtains where easily sucked into place.
should be avoided around obstacles material and
instability spaces.
MAINTENANCE AND STORAGE:
Shut off power before maintenance and storage
1.If body with oil dirt, must be cleaned to avoid
discoloration,damage.
2.After maintenance and cleaning, the original
packaging to the order of the various components into
the box, placed in the dry place for safekeeping.
3.The appliance just to do general external cleaning and
maintenance.
4.Use neutral detergent, and then a clean, soft cloth to
wipe.
5.Avoid direct wash water.
6.Don't use thinner, toluene, acid lotion, oil to wipe,
to avoid discoloration or deterioration.
TROUBLESHOOTING
NOT
TURN
ON
NOT
TURN
OFF
To ensure good contact plug in
the power
The power cord
is not plugged
or bad
Do not press on
/ off key
Body has been
damaged
Send to a service point for
repair
Do not press
on / off key
Body has been
damaged
Send to a service point for
repair
Press on / off key
Press on / off key
SPECIAL NOTE:
We will remain the right to refinements and
modifications to the product and manuals, product
structure is subject to change without notice. Part of
the picture in the manual is a schematic diagram, for
reference only, if the picture does not match with the
physical, to prevail in kind.
INTRODUCTION
This heater has reasonable design,
beautiful shape, safe, reliable, easy to
operate, with high thermal efficiency, thermal
sensing fast, energy saving and long life and
other advantages, we use environmentally
friendly materials, suitable for families and
similar places.
TECHNICAL SPECIFICATION
L TG- 130 0M
L TG- 160 0M
L TG- 180 0M
L TG- 200 0M
L TG- 220 0M
220 V
5 0H z
1 305 W
1 600 W
1 800 W
2 00 0 W
2 20 0 W
PRODUCT STRUCTURE DIAGRAM
LEFT COLUMN
PROTECTIVE NETS
RIGHT COLUMN
LEFT CASTER
ASSEMBLY
RIGHT CASTER
ASSEMBLY
CONTROL COMPONENTS
THERMOSTAT
CASTERS ASSEMBLE WAY:
A. Bolts screwed the caster into
caster holder, and tighten it.
another caster is the same.
see Figure 1
B. Then the assembled caster snaped as
the direction of arrow into left
column and right column, the other
side of the caster assembly is the same
see Figure 2
C. After the assembled casters are
installed well, put the product upside
down, on the ground or other supporting
surface can be.
see Figure 3
INSTRUCTIONS FOR USE:
Before use to check whether the name label voltage and
frequency comply with local supply conditions.Boot three
minutes or so, there may be a slight odor, noise emitted,
this is normal and will not cause harm to human health.
Plug the power plug into AC220V well grounded and the
current capacity of more than 10A power outlet, then
power on.
Adjust gear switch to “Ⅰ” or “Ⅱ” level, or
press“Ⅰ”, “Ⅱ” together meantime,
ⅠGEAR SWITCH
ⅡGEAR SWITCH
Ⅰ+ Ⅱ = Ⅲ ( 2 gear switch together is ma x . po w e r in p u t )
ELECTRICAL SCHEMATICS
adjust the
temperature knob according to you.
TIP OVER PROTECTION:
1.Products must be placed to the level for normally running.
2.In order to prevent accidents caused by the dumping
machine , we add tip over switch for protection, when
product horizontal tilt 60°. it will auto turn off all
outputs.you need to put the machine to the level to reboot.
Before first use, Please check your voltage requirements
is consistent with the product name label.
If the power cord is damaged, avoid a hazard,
must be replace by the manufacturer, or the
maintenance department or similarly qualified persons.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement