Battery Pack for AirChek 52 Operating Instructions

Battery Pack for AirChek 52 Operating Instructions
Operating Instructions
863 Valley View Road, Eighty Four PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]
www.skcinc.com
Battery Pack for
AirChek 52 Sample Pumps
To enhance battery life, SKC ships battery packs separate from the pump. Once installed,
completely charge battery pack before operating the pump (see pump operating
instructions). It may be necessary to charge the battery a few times before maximum
battery capacity is achieved.
1. To remove a battery pack, loosen two security screws on bottom of pump case
and allow them to fall to the out position.
2. Pinch battery pack release arms and pull the bottom half of the pump case
away from the top half.
3. To install a battery pack, align arms on top half of case with slots on either
side of the new battery pack housing. Ensure the back of the battery pack with
the charging jack is on the same side as the belt clip.
4. Slide battery pack up until arms click into place.
5. Push each security screw into the battery pack housing and tighten.
6. Charge the new battery pack using the charging jack on the back of the
battery pack.
Back of Battery Pack
Battery pack
release arms
Charging
jack
Battery pack
Security
screws in
out position
Use of a repaired or rebuilt battery pack voids any warranty and the UL Listing for intrinsic
safety.
Do not charge or operate pump from charger in hazardous locations!
Use only an SKC-approved charger and battery pack designed for the AirChek 52 Sample
Pump to ensure reliable performance. Failure to do so voids intrinsic safety and any
warranty.
Use of any device other than the approved battery pack to power the pump voids the UL
Listing for intrinsic safety and any warranty.
Failure to follow warnings and cautions voids any warranty.
Notice: This operating instruction may not address all safety concerns (if any) associated with this product and its use. The
user is responsible for determining and following the appropriate safety and health practices and regulatory limitations (if
any) before using the product. The information contained in this document should not be construed as legal advice, opinion,
or as a final authority on legal or regulatory procedures.
Form #40062 Rev 0907
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement