Calculation Software User Guide.

Calculation Software User Guide.

Step 1.

Click on the cog icon to start calculation.

Step 2.

Click on “Industrial Cooling”

Step 3.

Enter your desired “Project code” name.

Step 4.

Click on “INDOOR” or” OUTDOOR” depending on your application.

Step 5.

Click on the “Ambient” tab and enter your required internal and maximum external temperatures.

Step 6.

Click on the “Enclosure” tab and enter your enclosure dimensions.

Step 7.

Click on the “Covered side” tab and enter the location of your enclosure, for example free standing up against a wall as seen here.

Step 8.

Click on the “Layer” tab then choose “NON INSULATED”. Select enclosure material from the

“Thermal trans. Coefficient” drop down box.

Step 9.

Click on the “Components” tab and enter pre programmed devices from drop down box (select the

“New” button for each component). To manually enter components that are not pre programmed click on “Other” from the drop down box and manually enter components. Alternatively, if the power dissipation is known, enter the value directly into the “Power dissipated” space (if using this method, click on the “Refresh” button).

Step 10.

Click on the “Result” tab then click on the “Calculate” tab. Your ventilation or air conditioning option boxes will turn green if this is a suitable type of cooling solution for your application.

Tolerances can also be altered to show the closest suitable sized unit.

If your application requires more than one unit for installation reasons you can also alter the quantity amount.

Step 11.

At this point click the “Save” button and all your details for this project will be stored. Click the

“Print” button for a paper copy of calculations. Select the most appropriate form of cooling for your application - for example in the above case if you choose air conditioning,

click on the “Air Conditioner” button.

Step 12.

Now choose the unit most suitable and click on the “Card” button for a data sheet on the product.