advertisement
Q.
bloxx EC BC
The product line Q.series-EC has been designed for demanding measurements found in todays most industrial measuring and testing environments. The range and flexibility of the IO modules allows an optimized solution for each single task.
Data exchange with the automation level takes place via
EtherCAT interface.
EtherCAT is a real-time Ethernet interface with an IEC-Standard
IEC61158 open protocol.
In measurement and automation technology it is suited for accurate hard and soft real-time requirements. Short cycle times
(≤100 μs) and low Jitter for accurate synchronization (≤1 μs) are features of the interface.
Bus coupler for connection to EtherCAT Modules
Key features:
Bus coupler for connection of the modules Q.bloxx EC
Converting of the defined by EtherCAT LVDS (Low Voltage Differential
Signal) on standard Ethernet
Connection of up to 10 measurement IO modules
Power supply and interface link for up to 10 modules
(up to 80 measuring channels) via the rear industry-standard connectors
EtherCAT IN/OUT
4-pin M8 connectors A-coding Tx+, Rx+, Rx-, Tx-
USB interface for configuration
Micro USB to configure the Q.bloxx EC measurement and I/O modules using the configuration software ICP100
(internal USB/RS-485 converter)
Power supply of the modules 10 VDC up to 30 VDC
M12 connector for the supply of the bus coupler and of max. 10 connected measurement and I/O modules
Communication LED
4 LEDs indicate the Status RUN and communication
EC
IN
, EC
OUT
and LVDS
DIN rail mounting (EN 60715)
Gantner Instruments Incorporated www.gantnerinstruments.com [email protected]
9835 Carroll Centre Road, Suite 100 Toll Free: (877) 725-6997 (877 QBLOXXS) Toll Free Fax: (800) 303-9381
San Diego, CA 92126 USA Direct: (858) 537-2060 Direct Fax: (858) 537-2064
Q.
bloxx EC BC
Power supply
Bus coupler for connection to EtherCAT Modules
Power supply 10 up to 30 VDC, overvoltage and overload protection
Power consumption approx. 2 W, additional 4 W for each connected module, maximum 45 W
Environmental
Operating temperature -20 °C up to +60 °C
Storage temperature -40 °C up to +85 °C
Relative humidity 5 % up to 95 % at 50°C, non condensing
Mechanical
Dimensions (W x H x D) (35.6 x 118.8 x 142) mm
Case Aluminium and ABS
Weight approx. 400 g
Mounting DIN EN rail
Valid from March 2015. Specification subject to change without notice gantner-q.bloxx-ec-bc.pdf (Version 0616)
Gantner Instruments Incorporated www.gantnerinstruments.com [email protected]
9835 Carroll Centre Road, Suite 100 Toll Free: (877) 725-6997 (877 QBLOXXS) Toll Free Fax: (800) 303-9381
San Diego, CA 92126 USA Direct: (858) 537-2060 Direct Fax: (858) 537-2064
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project