Connecting & Disconnecting Cartridges

Connecting & Disconnecting Cartridges
Model: 8000
CONNECTING & DISCONNECTING CARTRIDGES
The Ezeekleen 2.5 HD is equipped with a unique collet locking system that allows cartridge
changes to take only seconds and requires no special training or tools.
To make a connection
1. Cut tube square
3. Push up to tube stop
Cut tube square. It is essential that the outside diameter be free of
score marks and that burrs and sharp edges be removed before
inserting into fitting. For soft thin walled plastic tubing we recommend the use of a tube insert.
Push the tube into the fitting to the tube stop. The collet (gripper)
has stainless steel teeth which hold the tube firmly in position
while the ‘O’ ring provides a permanent leak proof seal.
4. Pull to check secure
2. Insert tube
Fitting grips before it seals. Ensure tube is pushed into the tube
stop.
Pull on the tube to check that it is secure. It is a good practice to test
the system prior to leaving site and/or before use.
Disconnecting
Push in collet and remove tube
To disconnect, ensure the system is depressurized before removing the tube. Push in collet squarely against face of fitting. with
the collet held in this position, the tube can be removed. The
fitting can then be reused.
© 2009 - 2012 Oasis Dental Group Inc.™
www.oasisdentalgroup.ca
12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising