User manual | Wireless Connection Installation Manual Android

Memorial University of Newfoundland
Wireless Connection Installation Manual
Android
Last updated: July 2012
Department of Computing and Communications
Memorial University of Newfoundland
St. John’s, Newfoundland
Disclaimer
This document is written using a “vanilla” configuration of Android, any user of this guide should be
aware that third party programs may interfere with configuring the wireless network. This guide is
intended as a “best effort” setup. The steps detailed in this guide have been tested and working on
Android version 4.0 (Ice Cream Sandwich), using the built in wireless utility. Due to the nature of
wireless networking, additional wireless drivers and/or troubleshooting may be needed, but this would
have to be evaluated on a case-by-case basis and is to be understood by client and support personnel
that all work is done as “best effort”.
Android Mun Wireless Configuration
Requirements:
 An Android device supporting 802.1x authentication.
 Your wireless account, and SSID (network name) which can be generated online at
https://www.mun.ca/cc/services/network/wireless/dattool.php
Configuration
1. Go to “Apps”.
2. Tap “Settings” then tap “W-Fi”.
3. A list of each of the available networks, fac, stu, guest, eduroam & MunSetup should be
listed. To continue, tap on the network to which you were assigned.
4. In the boxes labelled “Identity” and “Password” enter your username and password then tap
“Connect”.
5. After a few seconds you should be connected.

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project