Mitsubishi Electric 4E 80VAD, 5E 100VAD Split-type air conditioner Installation Manual

The Mitsubishi Electric 4E80VAD and 5E100VAD are split-type air conditioners designed for use in homes and offices. They offer efficient cooling and heating capabilities, and feature a range of advanced technologies for comfort and energy savings.

PDF Download
Document
Mitsubishi Electric 4E80VAD, 5E100VAD Split-type Air Conditioner Installation Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Split-type design
  • Efficient cooling and heating
  • Advanced technologies for comfort
  • Energy saving features
  • Installation manual for outdoor unit

Frequently asked questions

The 5E100VAD is a larger unit with a higher capacity than the 4E80VAD, suitable for larger areas.

The maximum pipe length for the 4E80VAD is 25 meters, and for the 5E100VAD is 25 meters.

No, the installation manual states that the unit should be installed by a qualified installer. It is not recommended to install the unit yourself.

The unit uses the refrigerant R410A.

You can lock the operation mode by setting the SW1 switch on the outdoor controller board. To lock to COOL/DRY mode, set switch “4” to OFF, and to lock to HEAT mode, set switch “4” to ON.

You can lower the operation noise by setting the “5” switch on the outdoor controller board to ON. This may reduce the cooling or heating capacity.

You should pump down the system before disconnecting the refrigerant pipes to prevent refrigerant release. Refer to the installation manual for detailed instructions.
ALP:
Preparing document for printing…
0%